1) cam motion
凸轮偏心运动
2) eccentric cam
偏心凸轮
1.
This article puts forward a control algorithm of variable frequency and adjustable speed of an eccentric cam being applied to the shaping mechanism of ring spinning frames.
提出变频调速系统控制细纱机偏心凸轮成型机构的算法。
3) wabbler
[英]['wɔblə] [美]['wɑblɚ]
凸轮，偏心轮
4) eccentric cam
偏心圆凸轮
1.
Compared with other oscillating follower mechanical rules, analytics is made on the commoneccentric cam mechanism and power, as given the practical scope and the basic parameters.
对常用的偏心圆凸轮从动件进行运动和动力分析，并与其它从动件常用运动规律进行比较，推荐其应用范围及基本参数的选取范围。
2.
The paper brings forward and analyzes the non-dimensional formulas of setover eccentric cam from the aspects of the travel, displacement, speed and velocity of the moving parts.
提出了偏置式偏心圆凸轮机构从动件的行程、位移、速度、加速度的无量纲表达式,并对其进行分析。
5) eccentricity camshaft
偏心凸轮轴
1.
By analyzing the forging process of eccentricity camshaft,the causes of un-accepted forgings would be found,and the displacement process would be shifted forward later on for the final heat area forging reduction.
通过对偏心凸轮轴锻造工艺分析,找出锻件不合格原因,将错移工序前移,最后一火局部镦粗修整。
6) camshaft eccentric
凸轮轴偏心轮
补充资料：在AutoCAD中偏心圆锥与偏心圆台实体的画法
现在要画一个偏心圆锥,底面在WCS的XY平面上,圆心(0,0,0),半径100,顶点(300,0,400)在ZX平面上.
1)连接PA,PB. A(-100,0,0) B(100,0,0)
图1
在当前坐标下:
2)延长PA到C,使PA=CA;延长PB到D,使PB=DB;
3)连接CD;
4)以CD为直径画圆;
5)用XLINE命令中的二等分选项作角CPD的角平分线PO,交CD于O;
6)过O作CD的垂线,交圆于E,F;
图2
7)用三点UCS命令,取三点为:O,P,C;
8)过点O作PO的垂线GO,交PC于G;
图3
9)再次用三点UCS命令,取三点为O,F,G;
10)现在就可以画椭圆锥了!
cone-e-c-捕捉O点-捕捉F点-捕捉G点-a-捕捉P点;
图4
11)回到WCS,剖切椭圆锥
SL-选择椭圆锥-回车-XY-回车-捕捉P点.
12)删除辅助线条.
图5
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条