1) intercrystalline recrystallization
晶间再结晶
2) remelt junction
再结晶结
3) recrystallized grains
再结晶晶粒
1.
Effects of solution treatment temperature on the recrystallized grains,the second phases,electrical conductivity and tensile properties of cold rolled Al-1.
结果表明:合金在520℃~560℃之间进行固溶处理时,随着固溶温度的升高,其再结晶晶粒尺寸变化不大,而第二相粒子的数量明显减少;且固溶态合金的伸长率也随着固溶温度的升高而增大,560℃固溶后伸长率最大。
4) recrystallization twin
再结晶孪晶
5) recrystallization
再结晶
1.
Coupling of FEM with Monte Carlo for simulating recrystallization in cold rolling pure aluminum sheet;
有限元与Monte Carlo方法耦合的冷轧纯铝板再结晶模拟
2.
Study of recrystallization and strengthening of ODS alloys;
氧化物弥散强化合金的再结晶行为及强化机理的研究
3.
TEM study on recrystallization mechanism of IF steel;
IF钢冷轧及再结晶初期微观组织的TEM研究
6) Re-crystallization
再结晶
1.
The results show that re-crystallization of the electrodeposited chromium layer occurs in a manner of gradient in the coating thickness direction after firing 3000 rounds.
结果显示:经3000发射击后,复合镀铬层沿着涂层厚度方向呈现梯度性再结晶,其组织由射击前的柱状晶粒团簇逐渐转变成等轴晶粒团簇,这导致镀铬层的硬度梯度分布;高收缩性铬层的表层晶粒成长最大,其相应的硬度由初始的960HV左右急剧下降到330HV左右。
2.
Lattice deformation stored energy at different cold-rolled deduces in non-electrical steels and the effect on re-crystallization texture are investigated by x-ray diffraction technique.
用X-射线衍射方法研究了不同压下率条件下冷轧无取向电工钢中各个晶体学方向的点阵畸变储能及其对再结晶织构的影响。
补充资料：再结晶
见回复和再结晶。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条