1) high aspect ratio region
大长宽比区
2) Large aspect ratios mesh
大长宽比网格
3) broad in the beam
宽长比例较大
4) aspect ratio
长宽比
1.
The geometric model of Al_2O_3 grain is designed based on its crystal character,through ran- domly slicing the grain model with a given slenderness ratio with the emulation slicing system,the grain random section parameter-aspect ratio can be gotten.
根据Al_2O_3的结晶习性设计了它的多面体颗粒几何模型,并利用随机切割系统对已知高径比的颗粒进行仿真切割,同时通过切出的颗粒截面计算截面的长宽比算术平均值,从而建立板片状氧化铝颗粒的高径比和其平均截面长宽比的对应关系。
2.
Gives a formula to evaluate the buckling coefficient of the compressed flange of lipped channel beams by considering the distortional buckling mode, and presents a set of simplified formulae to calculate the limit values of the aspect ratio α for buckling coefficient not less than 4.
０时板件长宽比α的限值以及在板件长宽比超过此限值时ｋｆ的最低值。
3.
The simulation results showed that the fiber aspect ratio was increased while increasing the mass flow of single hole and decreasing the spinning temperature and quenching initial height,but was considerably decreased while increasing the aspect ratio of the spinneret.
模拟纺丝结果表明,增加单孔质量流量,降低纺丝温度及侧吹风起始高度,纤维长宽比提高;喷丝孔的长宽比增大,纤维长宽比大幅度降低。
5) length-width ratio
长宽比
1.
Based on the connecting strength of soil,the effects of foundation length-width ratio on base additional stress and depth of compressed layer were discussed.
基于土的连结强度,研究基础长宽比对基底附加应力和压缩层深度的影响。
2.
This paper puts forward the method for determining length-width ratio of mixer.
长宽比是搅拌机的基本几何参数。
3.
A group of correlation output are obtained which is different in the vertical direction and horizon direction by changing the length-width ratio of two same rectangles as the target picture and reference picture.
通过采用两个相同的矩形作为目标图像和参考图像,改变矩形的长宽比,获得了一组在垂直方向和水平方向分布变化较大的相关输出,并分析了产生的原因。
补充资料：大长
1.首领。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条