1) parallel misalignment
平行度偏差
2) the parallel deviation
平行偏差
1.
It was introduced that the process of the D505 laser axes adjusting meter in installing drive equipment,using the point-test of 9-12-3 to measure the parallel deviation and the angle deviation of the axes of the electriclocomotive and the gear case, at the same time, to measure the adjustment value and level up the value of the frontfeet and the back, to do a real time adjustment.
本文简要介绍了D505激光轴对中仪在纸机传动设备安装过程中,利用9-12-3点法测量出电机轴和齿轮箱轴平行偏差和角度偏差,同时给出前脚和后脚的调整值和垫平值,并实时调整,用实例说明了D505的精确性和适用性。
3) position deviation
平行偏差(平偏)
4) Duplicate samples tolerance bias
平行样允许偏差
5) error of parallelism
平行度误差
1.
This paper has discussed the problem of the error of parallelism between the two used mirrors during establishing the fictitious length standard.
主要讨论在构建虚拟基线场的过程中所遇到的两反射镜面的平行度误差的影响问题,通过分析计算并前瞻可行的措施,在理论上证明了微小的平行度误差不会影响虚拟基线场的构建。
6) Parallelism error
平行度误差
1.
The authors proposed a mathematical model and the process program for evdluation of orientation least area value of parallelism error for line to line.
提出了线对线平行度误差定向最小区域评定的数学模型及其微机处理程序。
2.
This paper seeks another solution to the algorithm of the linear parallelism error and makes the algorithm of the linear parallelism error converge toward minimum area by moving outer cylinder axis to shorten its diameter constantly.
在空间直线平行度误差计算中另辟途径,通过移动包容小圆柱的中轴线,不断将包容柱的直径下降,从而使空间直线平行度误差的计算向"最小区域"收敛。
补充资料：逼近函数的偏差
逼近函数的偏差
deviation of an approxmating function
通近函数的偏差【山血位扣of ana即.油加tiI犯如‘丘.;yoo.e。。e np:6二:狱a沁川e‘中y。二明。。1 逼近函数g〔K和一个给定函数f任叨之间的距离p匆，f).在同一个类叨内可以考虑用不同度量p，譬如一致度量 p(g，f)一碧笃}g(x)一f(x)I，以及积分度量 /(。，，)一(i一(·)一，(·):“·)’‘’，p一和别的度量.至于逼近函数的类K则可以用代数多项式、三角多项式，还有f关于某个正交系的正交展开的部分和，这些部分和的线性平均，以及一些别的集之、
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条