1) crystal shape factor
晶体形状因子
2) volume shape factor
体积形状因子
1.
Using the proposed test methods,the specific surface area of coarse aggregates and the ratio of surface area shape factor to volume shape factor of coarse aggregates can be obtained,and the surface area fractal of coarse aggregates can be calculated by theoretical equations.
采用所提出的试验方法,可得到粗骨料的比表面积、粗骨科表面积形状因子与体积形状因子的比值,代入理论公式可求出粗骨料表面分维。
4) lens epithelium-derived growth factor
晶状体上皮源生长因子
1.
Protective role of lens epithelium-derived growth factor in human lens epithelial cells apoptosis induced by high ambient glucose
晶状体上皮源生长因子对高浓度葡萄糖诱导凋亡晶状体上皮细胞的保护作用
5) shape factor
形状因子
1.
Automatically discriminating overlapped cell based on shape factor analysis:a technical study;
基于形状因子分析的重叠细胞自动判别技术研究
2.
Research on relationship between shape factor and hydraulic conductance for flow in arbitrary triangular capillary;
任意三角形毛细管中水力传导率与形状因子关系研究
3.
Study of the thermal conductivities for the fluids and fluid mixtures with the shape factor corresponding states principle;
形状因子对应态原理研究流体及混合物的导热系数
6) form factor
形状因子
1.
A corrected Prohaska method for determining hull form factor;
确定形状因子的修正的Prohaska方法
2.
Study the measurements of the electromagnetic form factor of the proton on BES;
在BES上测量质子电磁形状因子的研究
3.
Based on the contrast state theory,the statistical mechanics model of form factor contrast state was established.
基于热力学对比状态理论，建立了形状因子对应态的统计力学模型。
补充资料：晶体管-晶体管逻辑电路
| 晶体管-晶体管逻辑电路 transistor-transistor logic 集成电路输入级和输出级全采用晶体管组成的单元门电路。简称TTL电路。它是将二极管-晶体管逻辑电路（DTL）中的二极管，改为使用多发射极晶体管而构成。TTL电路于1962年研制成功，基本门电路的结构和元件参数，经历了3次大的改进。同DTL电路相比，TTL电路速度显著提高，功耗大为降低。仅第一代TTL电路产品，就使开关速度比DTL电路提高5～10倍。采用肖特基二极管的第三代TTL电路，开关时间可缩短到3～5纳秒。绝大部分双极型集成电路，都是TTL电路产品。 |
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条