2) end surface crack
端面裂纹
1.
Using macroscopic, microscopic examination method, the end surface crack of V section guide rail was analysed.
用宏观、微观检验的方法,对V型钢导轨端面裂纹产生的原因进行分析。
3) crack tip
裂纹尖端
1.
Damage analysis of crack tip zone in metal sheets;
金属板材中裂纹尖端区的损伤分析
2.
Research of crack tip damage for metals material;
金属材料裂纹尖端损伤研究
3.
The electromagnetic stress on the crack tip in metal plate with strong current;
导电薄板内裂纹尖端区域的电磁应力
4) endness crack
终端裂纹
1.
The author introduces the base status of containment steel liner of Pakistan Chashma nuclear power plant C-2 project,discussses how to avoid the endness crack in the welding joints,as well as how to get along with the three-parameter of SAW,which is a good way to eliminate thinner width & higher reinforcement.
介绍了巴基斯坦恰希玛核电C-2工程安全壳钢衬里筒体的基本状况,论述了SAW焊接方法防止产生终端裂纹的方法,指出理顺主要工艺参数的匹配关系是消除焊缝宽度窄而余高大的基本控制方法,正确选择焊剂的颗粒度,并合理回收使用焊剂是减小气孔及焊缝表面压气、凹坑缺陷的重要途径,通过二次切割可减小翘曲等波浪变形现象。
5) leg end crack
腿端裂纹
1.
By analyzing the production process of angle steel produced by conticasting strand once, in this paper, the authors find out the main reasons for leg end crack in the production process of angle steel and present several feasible solutions.
本文通过连铸坯一火成材生产角钢生产过程分析 ,找出了角钢产生腿端裂纹的主要原因 ,并提出了几种切实可行的解决办法 。
6) crack on end side
端部裂纹
补充资料：端面
（～儿）圆柱形工件两端的平面。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条