1) circumferential stress
环向应力，周向应力
2) circumferential stress
周向应力
1.
In order to compare the distribution of circumferential stresses before graft (under the vein pressure) and immediately after graft (under the arterial pressure), the p(pressure)- V(volume) data of vein at certain axial extension ratio was measured and fi.
为了比较移植前(静脉压作用下)和移植后(动脉压作用下)静脉管壁的周向应力分布,本文通过检测一定轴向伸长比条件下静脉管的p(压力)——V(容积)试验数据,利用3参数的应变能密度函数对实验数据进行拟合,进而求得静脉管壁的残余应力和沿血管壁的周向应力分布。
2.
In this paper, the circumferential stress distribution along the arterial wall thickness was determined using p-V exponential relationship.
通过检测，得到在体轴向伸长比条件下血管段的压力－容积（ｐ－Ｖ）数据，利用指数函数关系，求得在一定内压作用下血管壁周向应力沿壁厚的分布。
3.
The theory on crack mechanics of maximum circumferential stress is used for deducing cracking angle and cracking stress of the cylindrical thin shell with crack under the action of twisting moment,and a crack criterion on Ⅰ-Ⅱ compound crack is established.
采用断裂力学的最大周向应力理论 ,推导出带有穿透裂纹的圆柱薄壳在扭矩作用下裂纹开始扩展的开裂角和开裂应力 ;建立了Ⅰ -Ⅱ复合型裂纹的断裂准则 通过分析该圆柱薄壳的破坏形态 ,确定其临界应
3) hoop stress
切向应力，周向应力，环状应力，箍应力
5) hoop stress
环向应力
1.
Through analysis about the polyethylene pipes in hydrostatic strength testing,the formula of axial,radial and hoop stress were inferred.
通过对聚乙烯管材静液压的受力分析,推导出了管材的轴向、径向、环向应力和边界计算公式。
2.
A calculation formula of limit to growth length when grout body cracked is deduced from the hoop stress of wholly bonded prestressed cable grout body,which is concurred between the hoop tension stress is created by pretension and the uniformly corrosion expansion force by cable body.
将全长粘结式预应力锚索注浆体受到的环向应力,考虑为预应力引起的注浆体环向拉应力和锚索体对注浆体的锈胀力共同作用,推导出锚索体均匀锈蚀导致注浆体开裂时的极限增长量计算公式。
6) annular stress
环向应力
1.
Adopting the general finite element computation software to analyze symmetry Y-type reinforced concrete bifurcation pipe in Hydropower Station, this paper has calculated annular stress and distortion distribution of reinforced concrete bifurcation pipe, and analyzed the influence that indide hydraulic pressure has on bifurcation pipe wall rock.
采用通用的有限元计算软件分析了水电站对称Y形钢筋混凝土岔管结构,计算出了钢筋混凝土岔管结构环向应力及变形的分布情况,并分析了内水压力对岔管围岩的影响。
补充资料：周向应力
分子式：
CAS号：
性质：圆筒状构件受内压或外压时沿圆周方向的应力。通常如化工设备中的有压力反应釜，压力管道的周壁等就是这种受力状态，这时的周向应力为拉应力。也有些特殊场合其内压是负压，周向出现压缩应力状态。从造成破坏的角度讲，人们显然关心的是周向拉伸应力状态。
CAS号：
性质：圆筒状构件受内压或外压时沿圆周方向的应力。通常如化工设备中的有压力反应釜，压力管道的周壁等就是这种受力状态，这时的周向应力为拉应力。也有些特殊场合其内压是负压，周向出现压缩应力状态。从造成破坏的角度讲，人们显然关心的是周向拉伸应力状态。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条