说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 色负差信号电压
1)  color-minus-difference voltage
色负差信号电压
2)  load signal voltage
负荷信号电压
3)  LVDS
低电压差分信号
1.
Based on field programmable gates array(FPGA),a method of implementing a long-range agreement transparent,highspeed LVDS and optical communication was firstly introduced.
介绍了利用现场可编程门阵列FPGA实现低电压差分信号—光纤接口的协议透明、远距离、高速数据传输系统。
2.
Using LVDS(low voltage differential signaling)protocol, the link-port transforms the 64 b*30 MHz data stream from DSP into (4 (b*)) 600 MHz data stream, which is connected to other link-ports on different boards.
它采用低电压差分信号(LVDS)协议,把DSP的64b*30MHz数据流转换成4b*600MHz数据流进行板间传输。
3.
This paper lays particular stress on new video chips for airborne application, mainly on PAL video and LVDS bus design.
介绍了几种新型的视频转换芯片在机载计算机系统上的应用 ,主要包括PAL制视频和低电压差分信号 (LVDS)视频总线设计。
4)  lvds: low voltage differential signal
低电压差动信号
5)  colour difference signal
色差信号
1.
Through size-research of the colour difference signals in colour TV-test illustrating picture, the phase and module of colour difference signals call be obtained simutaniously.
用插值法对彩色电视广播测试图中的色差信号进行定量研究,可以同时得到色差信号的相位和模。
6)  differential pressure signal
差压信号
1.
Analysis of differential pressure signal based on wavelet transform and higher-order statistics;
基于高阶统计量和小波变换的差压信号分析
2.
EMD is applied to the differential pressure signal of two-phase flow to obtain frequency components with different scales, and the normalized energy of the component is extracted as the feature of flow pattern identification.
应用EMD将差压信号分解成不同频率尺度上的单组分之和,并提取组分的归一化能量作为流型辨识特征量。
3.
Because the differential pressure signal of oil-gas two-phase flow was a typical non-stationary and multi-component signal,EMD was first applied to break up it into Intrinsic Mode Functions(IMFs) which can be divided into three frequency bands such as high-band(30~50 Hz),mid-band(5~30Hz) and low-band(0~5 Hz).
油气两相流差压信号是一典型的非平稳多组分信号,经验模态分解首先将差压信号分解成9阶本征模函数,按照频率范围可以划分为3个子带:高频带(30~50 Hz),中频带(5~30 Hz)和低频带(0~5 Hz)。
补充资料:安全特低电压
分子式:
CAS号:

性质:又称安全特低电压,指保持独立回路的,其带电导体之间或带电导体与接地体之间不超过某一安全限值的电压。中国国家标准规定工频电压有效值的限值为50V、直流电压的限值为120V。中国标准规定工频电压有效值的额定值有42V,36V,24V,12V和6V。特别危险环境中使用的手持电动工具应采用42V安全电压。有电击危险环境中使用的手持照明灯和局部照明灯应采用36V或24V安全电压。金属容器内、特别潮湿处等特别危险环境中使用的手持照明灯应采用12V安全电压。水下作业等场所应采用6V安全电压。具有安全电压的设备即III类设备。

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条