1)  electrical-resistance heating element
电阻加热元件
2)  resistance heating element
电阻加热元件
3)  stratit element
钼电阻加热元件，钨电阻加热元件
4)  globar resistor element
碳硅棒电阻加热元件<冶>
5)  electric resistance
电阻
1.
Effects of Annealing Temperature on Electric Resistance of Amorphous Cu_(50)Zr_(42)Al_8 Alloy;
退火对Cu_(50)Zr_(42)Al_8非晶合金电阻的影响
2.
Study on the electric resistance changes during dough fermentation for Chinese steamed bread;
馒头面团发酵过程中电阻的变化
6)  resistance
电阻
1.
Effect of strain on the electrical resistance of continuous carbon fiber monofilament;
连续碳纤维单丝的应变电阻效应
2.
Nonlinear resistance of carbon fiber reinforced cement based composites;
碳纤维水泥基材料电阻的非线性研究
3.
A study on the resistance minima in an amorphous alloy at low temperature;
非晶合金中的低温电阻率极小行为研究
7)  electrical resistance
电阻
1.
The influence of mold pressing parameters on electrical resistance of HDPD/CB composites;
模压条件对聚乙烯/碳黑PTC复合材料电阻特性的影响
2.
The electrical resistances of specimen are measured after the definite number of thermal cycle.
空气介质中在光辐射热疲劳试验机上进行热疲劳试验,在不同热循环周次下测量试样的电阻,并用SEM观察了热循环前后的组织。
3.
The damage of specimen owing to thermal fatigue was evaluated by the relative varieties both of Young`s modulus and electrical resistance,and the phase transformation and microstructure was analyzed also.
在空气介质中用光辐射热/机械疲劳试验机对-γTiA l的热疲劳性能进行了研究,采用电阻和动态弹性模量的相对变化率表征损伤,并对其物相和组织变化进行了分析。
8)  resistor
电阻
1.
Newly-developed coating system for metallic film resistors;
新型电阻(金属膜)专用镀膜机的研制
2.
Disposal of special resistor in circuit analysis;
电路分析中特殊电阻的处理
3.
A preliminary study on resistor direct preparation by laser micro-cladding resistor pastes on ceramic substrate;
激光微细熔覆电阻浆料直写电阻技术初步研究
9)  resistivity
电阻
1.
The Low Temperature Resistivity in Dilute Magnetic Alloys and s d Mixing Effect;
稀磁合金的低温电阻与s-d混合效应的影响
2.
Fiber with low resistivity was obtained and showed lower significant resistivity than the SiC fiber derived from polycarbosilane.
纤维的电阻率比单纯通过聚碳硅烷纤维得到 Si C纤维大大降
3.
It has been found that its resistivity is unstable owing to its complex conducting mechanism and its readiness of being influenced by circumstantial factors.
碳纤维增强水泥是一种新型机敏材料 ,其力学性能和电阻变化有密切的相关性 ,因此碳纤维复合材料的电阻测量是一个重要环节 。
10)  res.
电阻
补充资料：硅碳棒
分子式：
CAS号：

性质：红外分光光度计的一种常用红外光源。由高纯碳化硅制成两端粗，中间细的实心棒。中间为发光部分，直径约5mm，长50mm。两端粗，可降低电阻，使其在工作状态时两端呈冷态，免于发射强红外辐射。工作前不需预热，工作温度约1300℃，耗电200～400W。使用波数范围在5000～400cm-1。特点为坚固、寿命长、发光面积大，但工作时需用水冷却，以免温高影响仪器部件性能。

说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条