说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 正压力,过剩压力
1)  plus pressure
正压力,过剩压力
2)  overpressure [英]['əuvə'preʃə]  [美]['ovɚ'prɛʃɚ]
过剩压力
1.
Using balance depth principle,this paper calculates overpressure in the oilfield,set up overpressure system,analyzes the geological condition and control factor to form overpressure,and realizes that overpressure of chang7 serves as the important power for the oil primary migration.
从流体运移的角度,应用平衡深度法原理,计算出过剩压力,建立了研究区的过剩压力体系,分析产生过剩压力的地质条件及控制因素,认为长7段的过剩压力是油气初次运移的主要动力,并根据不同层段之间过剩压力差值,预测出有利目标区,为寻找类似油田提供了理论依据。
2.
Overpressure of Member 1 to 6 of Yanchang Formation has been resumed.
根据泥岩压实研究和古水动力数值模拟结果,恢复了长1-长6油层组泥岩最大埋深时期的过剩压力,分析了长2油层组和长6油层组的油势分布和演化历史,进而,结合前人的研究成果,认为过剩压力是油气初次运移的动力,并从油气运移的角度提出了延长矿区就近聚集型、顺层运移型和穿层运移型3种成藏模式。
3)  positive pressure
正压;正压力,剩余压力
4)  fluid overpressure
流体过剩压力
1.
By calculation of the fluid overpressure from Chang 7 to Chang 9 members of upper Trias Yanchang Formation and the analysis for the geochemistry of crude oil and resources,migration dynamics of the Chang 9 oil and gas was studied during the formation of Chang 9 o.
本文通过对古峰庄-王洼子地区延长组长7—长9油层组流体过剩压力的计算,并结合地球化学特征分析,对该地区长9油藏形成时的油气运移的动力特征进行了研究。
5)  overpressure [英]['əuvə'preʃə]  [美]['ovɚ'prɛʃɚ]
剩余压力
1.
Under 1 500 meters of ground,the compaction coefficient can be calculated by the half-log-arithm normal trend equation,and the overpressure can be calcu-lated according to the relation of interval transit time and forma-tion pressure.
东营凹陷南坡异常高压的分布与成藏关系密切,在1500m以下的埋深条件下,可以采用半对数式回归正常趋势线方程求取压实系数,再运用声波时差与地层压力的关系计算剩余压力。
6)  surplus pressure
剩余压力
补充资料:锅炉、压力容器、压力管道及特种设备定期检验


锅炉、压力容器、压力管道及特种设备定期检验
periodic inspection of boilers, pressure vessels, pressure piping and special equipment

  guolu YOli侧飞扣1 YOli gLJal对印ji tez陌叩劝以拍1 dingqi】,on四n锅炉、压力容器、压力管道及特种设备定期检验(peri诫c inspectionof城le。,p~切reves-Sels,p~二piPing ands衅过闪uiplr屺nt)为保证设备的安全使用,规定设备必须按一定周期进行法定的、强制性的检验。定期检验由政府设立的检验所、使用单位或行业检验站进行。检验单位及检验人员必须具有与所检设备相适应的资格。设备使用单位应该建立定期检验制度,做好检验计划,按时向检验单位提出申请。检验单位应该保证及时进行检验,检验按有关检验规则进行。检验时,设备使用单位应做好配合工作,提供必要的运行资料。检验完毕,检验单位要出具检验报告,对设备能否使用,要作出明确结论。如设备有缺陷,要提出是否修理、监护使用和报废的处理意见。锅炉压力容器安全监察机构根据检验机构的报告,发使用许可证书。有缺陷的,责令使用单位修理,修理后检验仍不符合安全要求的,则通知报废。使用单位逾期不进行定期检验,锅炉压力容器安全监察机构有权停止其设备运行。(陈亦惠)
  
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条