1) deformed ball diameter
变形球径
2) deformation path
变形路径
1.
The simulation results show that the multi-step forming can optimize the deformation path of sheet metal,make the deformation more uniformly,effectively restrain wrinkles and improve the deformation capacity of sheet metal.
结果表明:多道次成形可以优化板材的变形路径,使变形均匀,有效地抑制起皱,提高板材成形能力。
2.
The deformation path of sheet metal is optimized.
变形路径对于板材的成形质量有着重要的影响。
3) forming path
变形路径
1.
The multi-steps forming is studied with numerical simulation in this paper,at the same time,the effect of the thickness of sheet metal on the forming path is also simulated.
通过有限元数值模拟方法,分析多道成形工艺以及板材厚度对多道次成形的变形路径的影响。
2.
The multi-steps forming is studied with numerical simulation in this paper, at the same time, the effect of the thickness of sheet metal on the forming path is also simulated.
本文通过有限元数值模拟方法,分析多道成形工艺以及板材厚度对多道次成形的变形路径的影响。
4) radial deformation
径向变形
1.
The result shows that the radial deformation and the change of the flange plane is induced by the circumferential weld at the joint between the cylindrical shell and the flange, the radial deformation of the actual vacuum vesel is similar to the radial deformation of the model test, but the inclination slope of the flange in the model test is ten times bigger than in th.
结果表明，圆柱形壳体与法兰对接环形焊缝将引起壳体的径向变形及法兰平面度的变化；实际真空容器壳体的径向变形与模型试验壳体的径向变形相近，而环缝引起法兰平面外倾的斜率比模型试验法兰平面外倾的斜率小一个数量级。
2.
The radial deformation of the key part-flexspline of the drive system is calculated.
提出了一种基于静电驱动的新型机电集成传动系统,分析了该传动系统的基本工作原理,计算了传动关键零件柔轮的径向变形,给出了电场力的计算公式,得出了工作电压的解析式和输出力矩计算公式,讨论了输出力矩随主要系统参数的变化规律。
3.
The radial deformation of axial spring collar was studied by using Castigliano theorem,taking this as a foundation,and then the calculation formulae loose rotation velocity was derived while considering failure.
运用卡氏定理 ,分析了轴用弹性挡圈的径向变形 ,并在此基础上 ,给出了防止其工作失效的松动转速 ,为其合理设计提供了一定的参考。
补充资料：大坝内部变形观测(见水工建筑物变形观测)
大坝内部变形观测(见水工建筑物变形观测)
daba neibubianxing guanCe大坝内部变形观测见水工建筑物变形观测。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条