1) thermal degradation temperature
热退解温度
2) pyrolysis temperature
热解温度
1.
Effect of pyrolysis temperature on pyrolysate during fast pyrolysis of industrial lignin made by acid precipitation;
热解温度对酸沉淀工业木质素快速热解液体产物的影响
2.
By controlling only pyrolysis temperature of Fe(CO)5, polycrystalline iron fibers with tunable structure and chemical compositions were prepared by carrier gas flow induced method.
仅通过控制Fe(CO)5的热解温度(Td),用气流诱导法制备了化学组成与结构可控的多晶铁纤维。
3.
The change of final pyrolysis temperature,characteristic of waste,rate of gas yield and the key element of gas calorific value were studied in detail.
结果表明:实用热解设备的产气率高,理想热解温度在700℃以下。
3) pyrolytic temperature
热解温度
1.
Effects of pyrolytic temperature of phenanthrene on its adsorption to black carbon;
黑碳制备的不同热解温度对其吸附菲的影响
2.
To study the effects of pyrolytic temperature on the cation exchange capacity(CEC) of the crop-residue-derived black carbon(BC) and the Pb2+ and Cd2+ sorption on BC,the BC was isolated from the charred wheat residues by pyrolyzing the wheat residues under the oxygen-limited conditions for 24 h at 150,250,300,400 and 500 ℃ respectively.
为探讨热解温度对秸杆燃烧物提取黑碳阳离子交换量和重金属吸附量的影响,在150～500℃范围24h热解小麦秸秆,提取黑碳,测定黑碳阳离子交换量(CEC)和黑碳吸附铅(Pb2+)和镉(Cd2+)量。
3.
A gas chromatograph was used to measure the oxygen content of coal sample under different pyrolytic temperatures.
通过对采集煤样进行热解试验,用气相色谱仪测定了试验煤样在不同热解温度下氧气的含量,分析了氧气随温度变化规律,得出耗氧速率与温度的数量关系,用于判定煤炭自燃的阶段,为科学控制煤炭自燃、防止煤炭自燃的发生提供决策依据。
4) pyrogenation temperature
热解温度
1.
The influences of different pyrogenation temperatures and different addi- tives on the crystal morphology of basic magnesium carbonate were studied in order to improve its filling and dispersion.
以轻烧白云石粉料为原料,采用常压二次碳化法制备碱式碳酸镁[xMgCO3·Mg(OH)2·yH2O],研究了不同热解温度和不同添加剂对碱式碳酸镁晶体形貌的影响,并对其反应机理进行探讨,目的是提高碱式碳酸镁的填充性和分散性。
5) hot-roll annealing temperature
热轧板退火温度
1.
Influence of hot-roll annealing temperature on precipitation kinetics of β″ phase in 6××× alloy;
热轧板退火温度对6×××系铝合金β″相析出动力学的影响
6) thermal decomposition temperature
热分解温度
1.
The thermal decomposition temperature of the CPVC products in different conditions is compared.
对溶液氯化法生产过氯乙烯(CPVC)中影响产品质量的工艺参数进行了实验研究,比较了不同条件下制得的CPVC产品的热分解温度,确定了较适宜的工艺条件,提出实际生产装置中可以优化的工艺参数。
2.
The result showed that the thermal decomposition temperature of chlorinated paraffin reached 133 ℃ by adding 0.
3%时,氯化石蜡的热分解温度为133℃,比单独使用乙二醇二缩水甘油醚提高了15℃,热稳定效果较好。
3.
It is deduced from the bonding parameter topological index He that a quantitative relationship must be existed between He and the thermal decomposition temperature of some sulfates.
从键参数拓扑指数一般形式出发 ,导出计算硫酸盐键参数拓扑指数公式 ,用于关联硫酸盐热分解温度的计算 ,结果满
补充资料：铂电阻温度表(见电阻温度表)
铂电阻温度表(见电阻温度表)
表。bod旧nZu wendubiao铂电阻温度表见电阻温
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条