1) margin pressure setting
极限压力调整
2) margin pressure adjusting screw
极限压力调整螺钉
3) limiting torque adjustment
极限力矩调整
4) pump margin pressure setting
泵极限压力调定
5) limit pressure
极限压力
1.
Effect of media flow velocity on limit pressure of pipes during in-service welding;
介质流速对在线焊接管道极限压力的影响
2.
Finite element simulation of limit pressure pipeline with cracks using critical crack-tip-opening-angle;
以临界CTOA为参量的含裂纹管道极限压力有限元模拟
3.
Based on the numerical results,the remaining strength factor of the pipe can be obtained and limit pressure can be predicted.
运用有限元法对不同壁厚的管道进行在线焊接时的温度场进行了数值模拟,内部介质流动对焊接温度场的影响通过确定介质与管壁的换热系数来考虑,并根据温度计算结果,获得管道的剩余强度因子,进而获得管道的极限压力。
6) ultimate pressure
极限压力
1.
The load P-δ (normal deflection of plate center) curves, ultimate pressure P_(cr) of moderately thick plates were obtained through the test.
设计了四边简支板稳定性试验的加载、支承装置及试件,进行了中厚度钛合金板面内双向受压稳定性试验,测出了相应的极限压力Pcr;并与ANSYS软件的非线性有限元计算的结果作了比较,两者基本吻合;说明中厚度钛合金板采用有限元稳定性分析,选用20节点solid186体单元并计及材料非线性,是可靠有效的。
2.
In this paper, the finite element technique based on the hypotheses of ideal elastic plastic material and small defection was applied to systematically analyze the affections of plastic ultimate pressure, the type of the elements and constraints to the value of the numerical solution for welded pipe with T junction when the ratio of d/D is greater than or equal to 0.
5管道焊接三通的塑性极限压力及网格密度、单元类型和约束形式对数值解的影响，结果表明，在管径比 d/D≥ 0。
3.
The effect of design on the performance of rotary plunger vacuum pump is discussed mainly by way of analyzing such influencing factors as the ultimate pressure, pumping speed,power and noise on the pump operation.
主要讨论设计参数对滑阀真空泵性能的影响,对影响滑阀泵的极限压力、抽气速率、功率及噪声等性能的因素进行了具体的分析,并提出了有利于提高滑阀真空泵性能的设计思路。
补充资料：纯轧力矩(见轧制力矩)
纯轧力矩(见轧制力矩)
net rolling torque
ehunzha iiju纯轧力矩(net rolling torque)见轧制力矩。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条