说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 开关接地连接
1)  switch ground connection
开关接地连接
2)  earth switch
接地开关
1.
Brief analysis on performance and classification of earth switches for GIS;
简析GIS用接地开关的性能及分类
2.
In order to insure the personnel s safety when checking,for the switchgear above 35kV,on every bus we shall properly equip with earth switches,whose quantity and distance shall be determined according to the bus length and the electromagnetic induction voltage.
为保证检修人员在检修母线时的安全,电压为35kV以上的配电装置,每段母线上宜装设接地开关,接地开关的数量及安装间距根据母线长度及电磁感应电压大小确定。
3)  earthing switch
接地开关
1.
The earthing switch in high-voltage switchgear is a kind of mechanical earthing device used at the time of maintenance and repair to insure the safety of personnel.
高压开关柜中的接地开关是作为检修时,保证人身安全,用于接地的一种机械接地装置。
2.
kV Hengli Substation in Guangdong power grid is the first substation in China applying imported 500 kV hybrid gas insulation switchgear(HGIS),which is equipped with not only reliable mechanical interlock but also electric interlock for all of its circuit breakers,disconnectors, earthing switches, etc.
500kVHGIS内所有的断路器、隔离开关、接地开关等设备间不但有良好的机械联锁, 还配有电气联锁, 但与HGIS相连的有关二次设备的闭锁逻辑关系, 则需要进行相关的设计来完善。
4)  grounding switch
接地开关
1.
The selection of some technical parameters for the HVAC disconnector and grounding switch is a common problem.
对高压交流隔离开关和接地开关选用中经常遇到的一些技术参数的选择,依据国家相关标准进行了论述,提出要结合工程需要进行合理选择,才能收到既节省投资又可靠运行的效果。
2.
Based on the calculation results and IEC standard,the grounding switch s parameter is presented.
通过对计算结果的分析并结合IEC标准,提出本工程750kV同塔双回线路接地开关的参数要求:电磁感应电流和电磁感应电压及静电感应电流满足B类标准要求,静电感应电压超出B类标准,要求为55kV。
5)  connector switch
连接器开关
6)  switch ground terminal
开关接地接线柱
补充资料:快速接地开关


快速接地开关
high speed earthing switch

kua一sul一ed一ko一guon快速接地开关(high speed earthing switeh) 一种具有快速关合短路电流能力,专门用于电力系统人工接地的隔离开关。一般配有液压或电动的快速操动机构。在具有多个并联主变压器支路的电力系统中,为了节省投资,通常以快速接地开关代替主变压器支路的高压断路器。当主变压器本体发生故障时,主变压器保护起动高压侧快速接地开关进行合闸操作.造成电力系统人工接地,起动电力系统继电保护装t,致使输电线路对侧的断路器分闸,切断主变压器故障. 快速接地开关通常还装于气体绝缘金属封闭开关设备中,安装在每回出线的出口侧,用来闭合平行回路产生的感应电流。快速接地开关具有关合短路电流的能力,通常在110 kV电力系统中要求关合电流为80kA(峰值),在220 kV系统中为125 kA(峰值)。气体绝缘金属封闭开关设备中的快速接地开关,密封在SF‘气体绝缘的筒体中,关合短路电流的要求比较容易实现。而敞开式快速接地开关,当要求关合的短路电流较大时,往往用真空断路器来代替。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条