1) major vehicular movement
大量车流
2) maximum service Volume
最大服务车流量
3) vehicle flow
车流量
1.
The implementation of an adaptive vehicle flow traffic light control system
一种车流量自适应交通灯控制系统的实现
2.
According to the researches of the three main road ( Ping’an Road, Rui’an Road and Heng’an Road ) and the peripheral district of garden city of South Lake in Wuhan city,the statistic analysis of vehicle flow and traffic noise were carried out.
通过对武汉市南湖花园城的3条主干道(平安路、瑞安路和恒安路)及周边区域的实地调查,对其车流量及交通噪声进行了统计分析,在此基础上研究出该区域的车流量在休息日的日变化规律,并针对武汉市南湖花园城的实际情况提出了交通噪声污染的防治措施。
3.
This paper analyzes two important statistical indexes, vehicle flow and damage coefficient, and probes into the statistical distribution of random phenomena on superhighway.
对车流量、破坏系数两个重要的统计指标进行了分析,并对高速公路随机现象的统计分布作了简单探讨。
4) vehicle flux
车流量
1.
Design of the vehicle flux monitoring system at the roadway;
道口车流量监测系统设计
2.
While the traffic noise has been held in basically,the vehicle flux has showed distinct uptrend in recent years.
近年来 ,市内车流量呈显著攀升趋势 ,噪声污染基本保持平稳。
3.
The problem is caused by present road tolling system which adjusts vehicle flux to a unreasonable level.
讨论了我国收费道路的闲置问题,其原因是现行的车辆通行费制度反向调节车流量。
5) traffic volume
车流量
1.
On the basis of analyzing the FHWA traffic noise model,a simplified calculation model which shows the relationship between the increase of traffic volume and traffic noise increase,is put forward.
在分析影响交通噪声传播要素的基础上,基于FHWA公路交通噪声预测模型,提出公路交通噪声增加量随车流量变化的简化计算模型,探讨其在公路建设项目环境保护中的应用及其适用条件。
2.
According to the actual demand of the traffic volume tester for highway use,the module of serial-port communication in the control software for the traffic volume tester is designed and implemented using RS-232 serial-port communication interface.
针对用于高速公路的车流量测量仪的实际要求,采用RS-232标准异步串行通信接口,设计并实现了车流量测量仪控制软件中的串口通信模块。
3.
Presents a scheme for keyboard processing in control software for traffic volume tester and thus implements it.
提出并实现了车流量测量仪控制软件的键盘处理方案。
6) flow rates of vehicles
车流量
1.
Illustrated hardware circuit of flow rates of vehicles.
说明了车流量检测系统的硬件设计原理图,阐述了当车辆通过时红外传感器感受到信号经过检测电路实现脉冲检测的原理,叙述了车辆计数的设计思路和软件程序的设计与实现。
2.
A kind of system including software and hardware design which is used to monitor the flow rates of vehicles based on the infrared sensor is included.
介绍了基于红外传感器的车流量监测系统的总体方案以及软硬件设计。
补充资料：肾小管葡萄糖最大重吸收量试验
肾小管葡萄糖最大重吸收量试验
一种测定肾小管重吸收功能的试验。利用单位时间内肾小球滤出的葡萄糖量减去单位时间尿中出现的葡萄糖量，可计算出TMG值。测定方法：晨7时30分首次静脉注射40％葡萄糖溶液150ml，以后用30％葡萄糖溶液每分钟10ml速度维持输液。其他操作同*菊糖清除率，同时测定菊糖清除率以求出肾小球滤过率，然后按下式计算TMG值。TMG=PG×Cin－UG×V，式中PG为血浆葡萄糖浓度，Cin为菊糖清除率，UG为尿中葡萄糖浓度，V为每分钟尿量。正常人TMG平均值为340± 18．2mg/min／1．73m2。男性为300～450mg/min／1．73m2，女性约250～350mg／min／1．73m2。TMG的高低可反映有效肾单位的数量和功能，是测定近曲肾小管重吸收功能的指标之一。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条