1) percent of total linear shrinkage
线总收缩率
2) linear shrinkage
线收缩率
1.
The effects of pyrolysis temperature and soaking time on ceramic yield,linear shrinkage,mechanical properties and microstucture were investigated.
研究了热懈温度和保温时间对陶瓷产率、线收缩率、力学性能以及微观结构的影响。
2.
The effects are investigated of nano-Al_2O_3powder additive on sintering behaviors of alumina ceramics,such as volume density,water-absorbing rate,porosity,linear shrinkage.
研究了纳米A l2O3粉添加对粗晶氧化铝陶瓷烧结行为,如体积密度、吸水率、气孔率、线收缩率的影响。
3.
The microstructures and properties such as linear shrinkage, ceramic yield and flexural strength of active filler Al_containing polycarbosilane(PCS)_derived ceramics pyrolyzed at different temperatures were investigated.
研究了裂解温度对活性填料Al-聚碳硅烷裂解陶瓷的线收缩率、陶瓷产率、力学性能等的影响 。
3) line contraction percentage
线收缩率
1.
The effects of solidified agent, nanometer silicon dioxide powder and calcium carbonate powder on line contraction percentage of silicon rubber mould were discussed in this paper.
本文主要研究了固化剂、纳米二氧化硅粉和碳酸钙粉等外加剂对硅橡胶模具线收缩率的影响。
2.
The line contraction percentage of the sintered samples were investigated.
通过在原料中添加磷酸盐玻璃粘接剂改善HA生物陶瓷的烧结性能,测定试样的线收缩率,研究了粘接荆对HA植入体烧结的影响。
4) process shrinkage
多次收缩;收缩率总校正
5) contraction rate of integral curve
路线束收缩率
6) total shrinkage
总收缩
1.
The influence of different water-cement ratio on early-age autogenous shrinkage and total shrinkage of concrete under dry condition is experimented in this paper.
进行了不同水灰比对混凝土早期自收缩及干燥条件下总收缩影响的试验研究。
补充资料：断面收缩率
分子式：
分子量：
CAS号：
性质：材料的塑料性指标之一。材料受拉力断裂时断面缩小，断面缩小的面积与原面积之比值叫断面收缩率，以ψ表示。单位为%。
分子量：
CAS号：
性质：材料的塑料性指标之一。材料受拉力断裂时断面缩小，断面缩小的面积与原面积之比值叫断面收缩率，以ψ表示。单位为%。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条