说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 零序相量
1)  zero sequence phasor
零序相量
1.
In order to solve the problem of on-line location of single line-to-ground fault in the neutral point non-grounded system,this thesis proposes a zero sequence phasor method for on-line fault location which is based on the synchronized phasor of zero sequence voltage and current.
为解决中性点不接地配电网单相接地故障的在线(带电)故障定位问题,本文提出了基于零序电压、零序电流同步相量的在线故障定位零序相量法;在此基础上,计及测量误差的影响,提出了该方法的实用判据。
2)  zero phase sequence coponent
零相序分量
3)  zero sequence
零[相]序,零序
4)  zero phase-sequence
零相序
5)  method of phasor comparison of zero-sequence current
零序电流相量比较法
6)  zero-sequence component
零序分量
1.
A zero-sequence component imposed vector control system of induction machine based on three-level NPC(Neutral Point Clamped) inverter is proposed,which adopts direct rotor-flux-oriented vector control mode.
提出一种基于三电平中点箝位(NPC)逆变器的零序分量注入型感应电动机矢量控制方案。
2.
Because there is no need for acquiring the zero-sequence component,this principle can eliminate the effect of zero-sequence mutual inductance between coupling lines.
由于该方法中没有用到线路两端的零序分量,消除掉耦合线路之间零序互感对测距的影响。
补充资料:零序电流互感器
分子式:
CAS号:

性质:剩余电流型漏电保护装置的检测元件。其铁心多是环形的。所有电源线(两根、三根或四根)穿过互感器铁心构成互感器的原边;其二次线圈与极化电磁铁或电子线路联接。正常运行时,互感器一次边各线在铁心中产生的磁通互相抵消,二次线圈不产生感应电动势,漏电保护装置不动作;当后方发生漏电或有人触电时,出现剩余电流,二次线圈产生感应电动势,漏电保护装置动作。纯电磁式剩余电流型漏电保护装置的零序电流互感器必须具有很高的灵敏度。其铁心用铁镍合金或非晶态材料制成。

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条