说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 成穴原理
1)  The principle of forming sinus
成穴原理
2)  Punching mechanism
成穴机理
3)  Yuan-Source Point
原穴
1.
Objectives: To observe the superficial conductive volume changes of Encephaloma patients\' Yuan-Source Points before operation and the correlation between physiology and pathology with electric characteristic of the acupoints.
目的:观察脑瘤病人原穴体表导电量的变化规律,及其穴位电特性在反映人体生理病理变化方面的相关性。
4)  synthetic principle
合成原理
1.
The synthetic principle and preparation process of tin methanesulfonate were introduced, the product composition was analyzed and the influence of experiment conditions on the yield of tin methane- sulfonate was studied.
介绍了甲基磺酸亚锡的合成原理和实验步骤,分析了产物成分,研究了实验条件对甲基磺酸亚锡产率的影响。
2.
Its synthetic principle,process,factors on reaction control and effects of the product on concrete performance are described.
本文介绍了其合成原理、合成方法、反应控制因素及成品对混凝土性能的影响。
5)  Spinning principle
成纱原理
6)  Gelation principle
成胶原理
补充资料:成核生长机理
分子式:
CAS号:

性质:理想晶面上金属电结晶过程的理论。此理论认为,在理想平整的晶面上,由于不存在“生长点”,因此,晶体继续生长的前提是在晶面上出现新的晶核。晶核的形成是晶体生长过程的速率控制步骤。在未完成的理想晶面上,晶面的继续生长只能在少数占有最低能量位置的“生长点”或“生长线”上进行。金属离子在晶面上任一位置都可放电并形成“吸附原子”,然后通过扩散转移到“生长线”和“生长点”上。

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条