1) metal plate structure
薄板金属结构
1.
This paper presents a new method for damage detection of metal plate structure by actively using Lamb wave.
理论分析和实验结果表明:Lamb波主动监测技术可以有效识别薄板结构的损伤,并进行损伤定位和等级评估,可以用于薄板金属结构的损伤识别和健康监测中。
2) Metallic thin film structure
金属薄膜结构
3) Thin metal plate
金属薄板
1.
Study on typical rupture modes of thin metal plates under normal impact by conical-nosed missiles;
金属薄板在圆锥头弹体正冲击下的破裂模式
4) sheet metal
金属薄板
1.
According to the electromagnetic wavetransmitting equation in good conductor,get the eddy currents 'heating power in sheet metal,then some factors that affect heating power are di-scussed.
根据良导体中的电磁波基本方程,导出了针对金属薄板涡流的热功率公式,讨论了影响其热功率的因素,对电磁加热的实际应用有一定的意义。
2.
In order to study the laws and mechanisms of plasma arc forming,an experimental investigation was performed with 1Cr18Ni9Ti and Q235 sheet metals scanned forward and backward by moving it with respect to the stationary plasma arc.
为了研究金属薄板等离子电弧加热弯曲成形的规律及机理,采用等离子电弧沿直线来回对1Cr18Ni9Ti和Q235薄板进行加热弯曲成形实验。
3.
In this paper,the characters of flexible forming of sheet metal using plasma arc are introduced,and its mechanism is analyzed.
介绍了等离子电弧加热金属薄板柔性成形的特点,分析了等离子电弧柔性成形的机理。
5) metal sheet
金属薄板
1.
Instead of the rather complicated analytical method and computer aided numerical method for solving two dimensional steady state heat conduction problem of perforated metal sheets this paper proposes an electroconductive paper based thermoelectrical analogy method.
开孔金属薄板的二维稳态导热问题采用分析解和计算机数值解都相当复杂，不便实用。
6) sheet metals
金属薄板
1.
1～8《Sheet metal formability and test methods》were a set of standards for sheet metals forming and their metallurgical industry,which might be divided into three parts.
1~8《金属薄板成形性能与试验方法》是一个同时面向金属薄板冲压成形生产以及金属薄板冶金制造的系列性成套技术标准,其结构分为3大部分,共包含8个子标准。
补充资料：薄板
薄板
sheet
b0Obon薄板(sheet)厚度为0.2一4mm、以单张定尺供应的板材。生产方法主要分为热轧和冷札两类。现代热连轧机生产(见热连札宽带钢生产)的薄板最小厚度为1.Zmm。以叠轧方式热轧(见登札薄板生产)则能生产最小厚度为0.28mm的叠轧薄板。现代冷轧机生产的薄板，厚度更薄(0 .Zmm以下)且尺寸公差更为严格。 (李生智李隆旭)
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条