1) link-measuring standard
链路度量标准
1.
After an analysis and comparison of three most commonly used link-measuring standards in wireless sensor networks at present, it is concluded that there exists the lowest threshold of received signal strength (RSS) to satisfy a certain packet reception rate (PRR).
对无线传感器网络中目前最常用的3种链路度量标准进行分析和比较得出,在满足一定收包率要求时,节点的接收信号强度存在一个最小阈值。
2) criteria of measurement
度量标准
1.
Based on the discussions on the modes of failure in the studies of bearing capacity of foundations,the width of the acting plane of design loads and the criteria of measurement of the stability of the bearing capacity of foundations,it is held that the mode of failure of a gravity jetty is unidire.
通过对地基承载力研究中的破坏模式、设计荷载的作用面宽度、地基承载力稳定性度量标准等问题的讨论,认为:重力式码头是单向破坏模式,且需同时考虑整体破坏与局部破坏;直立式防波堤应是双向破坏模式,同样需考虑整体破坏与局部破坏。
4) standard measure
标准量度
5) standard of measurement
量度标准
6) standard communication link
标准通信链路
补充资料：可公度量和不可公度量
可公度量和不可公度量
ommensulble and incommensuable magnitudes (quantities)
可公度t和不可公度t【~e璐u由lea目in~men-su.ble magultodes(quanti柱es);“洲口Mel娜M毗“”“”-113Mep目M曰e肠eJ皿，一皿曰』 如果两个同类量(例如两个长度或两个面积)具有或不具有公度(common measure，即另一个同类量，所考虑的两个量都是这个量的整数倍)，则相应地称这两个量为可公度量或不可公度量.正方形的边长和对角线，或圆的面积和丫的半径的平方，都是不可公度量的例尹.如果两个量是可公度的，则‘l艺们的比是有理数;相反，不可公度量忿比是无理数、
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条