1) MEMS coriolis vibrating gyro
![点击朗读](/dictall/images/read.gif)
微机电哥氏振动陀螺
1.
The analysis for the control system(CVG) of MEMS coriolis vibrating gyro includes the control of drive mode and sense mode.
微机电哥氏振动陀螺控制系统分析主要包括驱动模态和检测模态两个部分。
2) Coriolis vibratory gyro
![点击朗读](/dictall/images/read.gif)
哥氏振动陀螺
1.
This paper introduces the operating principle, base structures and model equation of Coriolis vibratory gyros in accordance with the research improvements in china and abroad.
结合国外和国内的研究情况,介绍了哥氏振动陀螺的工作原理、基本结构和模型方程,供哥氏振动陀螺的研究人员和使用人员参考。
2.
This paper introduced the operating principle, basic structures and model equation of Coriolis vibratory gyros in accordance with internal and international study state.
本文结合国外和国内的研究情况,介绍了哥氏振动陀螺的工作原理、基本结构和模型方程,供哥氏振动陀螺的研究人员和使用人员参考。
3) vibrating wheel micromechanical gyroscope
![点击朗读](/dictall/images/read.gif)
振动轮式微机械陀螺
1.
Optical testing of dynamic characteristic of vibrating wheel micromechanical gyroscope;
![点击朗读](/dictall/images/read.gif)
振动轮式微机械陀螺动态特性的光学测试
4) silicon micromechanical vibrating gyroscope
![点击朗读](/dictall/images/read.gif)
硅微机械振动陀螺
5) micromachined vibratory gyroscope
![点击朗读](/dictall/images/read.gif)
微机械振动陀螺仪
1.
In order to improve the output signal s sensitivity of micromachined vibratory gyroscope,the frequency of the driving voltage is required to be equal to the resonant one of the gyroscope s driving mode.
为了提高微机械振动陀螺仪输出信号的灵敏度,通常要求驱动信号频率与陀螺仪驱动模态的谐振频率相匹配,且驱动信号幅值稳定。
6) silicon micromachined vibratory gyroscopes
![点击朗读](/dictall/images/read.gif)
硅微型机械振动陀螺仪
补充资料:点振子振动和点电极振子振动
分子式:
CAS号:
性质:又称点振子振动和点电极振子振动。振动能量绝大部分集中在点电极范围内,形成“能量封闭”的振动模式。振子电极面远小于压电陶瓷片的总面积,且与厚度有适宜的匹配关系。在交变电场作用下,沿厚度方向产生振动,其振幅随着至电极中心距离的增加,呈指数式衰减。谐振频率与压电陶瓷片的厚度有关。为提高频率通常将压电陶瓷片磨得很薄,有时考虑到压电陶瓷自身强度太低,可用特制的陶瓷片作垫片来防止压电陶瓷片损坏。常用于高频场合。
CAS号:
性质:又称点振子振动和点电极振子振动。振动能量绝大部分集中在点电极范围内,形成“能量封闭”的振动模式。振子电极面远小于压电陶瓷片的总面积,且与厚度有适宜的匹配关系。在交变电场作用下,沿厚度方向产生振动,其振幅随着至电极中心距离的增加,呈指数式衰减。谐振频率与压电陶瓷片的厚度有关。为提高频率通常将压电陶瓷片磨得很薄,有时考虑到压电陶瓷自身强度太低,可用特制的陶瓷片作垫片来防止压电陶瓷片损坏。常用于高频场合。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条