1) walk-angle
步角
1.
The angles made of the foot-length eigenvectors on left-walk-lines with the left-walklines are defined as the left-walk-angles,and the angles made of the foot-length eigenvectors on the right-walk-lines with the right-walk-lines are defined as the right-walk-angles.
定义左步行线上足长特征向量与左步行线间在前进方向的夹角为左步角,右步行线上足长特征向量与右步行线间在前进方向的夹角为右步角。
2) stepping angle
步距角
1.
The relationship between stepping angle to the optimal starting frequency,between rotating inertia to the optimal starting frequency,between starting tor.
通过分析步进电动机起动时的运动规律及其矩频特性,建立了最佳起动频率的数学模型,并分析了步距角、传动系统转动惯量、起动转矩、负载转矩等因素对最佳起动频率的影响。
2.
The drive power supply holded the primary characterstics for the motor and it raised four times for stepping angle accuracy in the motor.
使用该驱动电源除可保持电机原有的性能外，还可使电机的步距角精度提高４
3.
The test shows that this system can subdivide further the stepping angle of stepping motor to satisfy the application needs of high precision and high resolution capability.
实测结果表明,该系统可进一步细分步进电机的步距角,满足了高精度及高分辨率应用需求。
3) Step angle
步距角
1.
It is a main problem that how to make the step angle more even all the while.
细分技术作为一种提高步进电机步距分辨率的手段已被大量采用,步进电机采用细分驱动能提高分辨率,减少力矩波动,解决步进电机的低频共振问题,如何使步进电机的微步距角更均匀,一直是细分技术所研究的主要问题。
2.
The step angle of stepping motors is determined by their numbers of phase and numbers of rotor tooth.
众所周知，步进电动机的步距角主要由它的相数和转子齿数决定。
4) same stepping angle
等步进角
1.
A special single-phase stepping motor,which is controlled by pulse of different width to export a fixed directional and rotary movement with the same stepping angle,is described in this paper.
简介了一种可以由不等宽脉冲控制、产生相等步进角的单向旋转运动的特殊单相步进电机 ,并详细讨论了其工作原理、结构和特点。
5) tripod gait
三角步态
1.
Research on miniature hexapod bio-robot and its tripod gait;
微型六足仿生机器人及其三角步态的研究
2.
By making use of infrared LED switch as detecting sensor for hexapod robot movement gait, the tripod gait movement can be realized.
利用光电开关作为六足机器人步态检测传感器,使机器人能够按照三角步态进行行走。
3.
The robot could walk exactly on tripod gait and climb on the gradient less than 50°.
结果表明:机器人能严格按照三角步态,行走于小于等于50°的坡面,且方向正确、姿态平稳,腿部能顺利吸附、剥离地面;通过对机器人爬坡实验的分析表明:为了增加足垫吸附力,必须选择质地柔软的材料作为足垫,在足垫上雕刻适当深度与密度的凹槽,着地后对足垫施加一定的压力,选用适当浓度的粘液并产生较薄的液体膜。
6) external angle of stair step
踏步阳角
1.
Reinforcement protection technology for external angle of stair step;
楼梯踏步阳角采用钢筋护角新工艺
补充资料：步距误差
分子式：
CAS号：
性质： 光学掩模版列或行上相邻功能图形中，某图像的点与相应图像对应点之间的距离叫步距。实测步距与规定步距之差即步距误差。
CAS号：
性质： 光学掩模版列或行上相邻功能图形中，某图像的点与相应图像对应点之间的距离叫步距。实测步距与规定步距之差即步距误差。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条