说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 晶胶
1)  cryogel
晶胶
1.
A novel supermacroporous cryogel with sulfo binding groups used in cation-exchange monolith was prepared by in-situ grafting of 3-allyloxy-2-hydroxy-1-propanesulfonic acid sodium salt (AHPSA) onto the pore surfaces of polyacrylamide-based cryogel.
采用原位接枝法,将3-烯丙氧基-2-羟基-1-丙磺酸钠(AHPSA)接枝到聚丙烯酰胺基晶胶基质孔隙内表面,制备得到了阳离子交换型连续床用的带磺酸基超大孔晶胶介质。
2)  Colloid crystal
胶晶
1.
Three-Dimentionally Ordered macroporous titanium-silica mixed oxides were successfully synthesized by using polystyren sphere colloid crystal as the template and the sol of tetraethyl silicate and tetrabutoxy-titane as the filling fluid.
以聚苯乙烯微球离心后形成的三维规则排列的胶晶作模板,用钛酸丁酯和正硅酸乙酯分别和水、乙醇等配制成的混合溶胶填充微球之间的间隙,然后原位形成凝胶,最后通过焙烧(<5℃/min;300℃,5h;570℃,5~10h,空气流速1L/min)除去微球得到三维规则排列的大孔钛硅混合氧化物。
2.
Three dimensionally ordered macroporous silica was successfully synthesized using latex sphere colloid crystal as template and sol of tetraethyl orthosilicate, water, ethanol and hydrochloric acid as filling fluid.
以聚苯乙烯微球离心后形成的三维规则排列的胶晶作模板 ,以正硅酸乙酯、水、乙醇和盐酸等配制的溶胶填充微球间的间隙 ,然后原位形成凝胶 ,最后通过焙烧除去微球得到三维规则排列大孔二氧化硅材料 。
3.
Periodic macroporous titanium dioxide were successfully synthesized using PS colloid crystal as templates which were made by centrifuging latex sphere, filling in the voids with sol of terabutoxy_titane, and then transforming into gel in situ and removing latex sphere by calcinations.
以聚苯乙烯微球 (LatexSphere)离心后形成的三维规则排列的胶晶 (colloidcrystal)作模板 ,用钛酸丁酯、水、乙醇等配制的溶胶填充微球之间的间隙 ,然后原位形成凝胶 ,最后通过焙烧除去微球得到三维规则排列大孔TiO2 材料 (3DOM)。
3)  colloidal crystal
胶晶
1.
Polystyrene colloidal crystals were assembled by natural sedimentation,centrifugation and vertical deposition methods.
采用自然沉降法、离心法和垂直沉积法组装了聚苯乙烯胶晶。
2.
Polystyrene colloidal crystal films(PCCF) were assembled by vertical deposition method.
采用垂直沉积法组装了三维聚苯乙烯胶晶膜,并用其为模板制备了三维有序大孔(3DOM)SiO2膜。
4)  colloidal crystals
胶体晶体
1.
Preparation of monodisperse SiO_2 particles for assembling colloidal crystals;
组装胶体晶体用单分散二氧化硅颗粒的制备
2.
Preparation of monodisperse SiO_2 colloidal spheres and the assemble of colloidal crystals with high crystalline quality;
单分散SiO_2胶体球制备及其胶体晶体组装
3.
Fabrication and characterization of silica colloidal crystals by vertical deposition method;
垂直沉积法制备二氧化硅胶体晶体及其表征
5)  crystal adhesive
水晶胶
1.
Factors affecting gelation time of crystal adhesive for decorations;
影响饰品用水晶胶凝胶时间的因素
6)  colloid crystals
胶粒晶体
1.
It was shown that the evaporation was blocked by the polystyrene colloid crystals.
通过调整悬浮液的蒸发温度和组装面积,可以有效地控制悬浮液相浓度的变化,从而实现在相浓度基本不变的情况下组装出高质量的聚苯乙烯胶粒晶体。
补充资料:胶态微晶室温磷光法
分子式:
CAS号:

性质:将被分析物制成胶态微晶,在水溶液中形成均匀稳定的分散体系。利用在胶态微晶悬浊液界面上产生的室温磷光(RTP)信号进行定量分析的一种流体室温磷光法。体系可不必除氧,无需使用外部重原子微扰剂。但重现性差,磷光强度与分析物浓度不成直线关系。

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条