1) squeeze mode
挤压式
1.
This paper proposed a design plan of squeeze mode MR damper for the purpose of small displacement and big damping force and emulated the magnetic circuit based on ANSYS.
根据小位移大阻尼力的减振要求,提出了一种挤压式磁流变阻尼器的设计方案,并基于ANSYS进行了磁路的仿真,证明设计的方案是可行的。
2) closed extrusion
闭式挤压
1.
A new type of structure of closed extrusion dies with locking hooks is put out.
本文给出了钩子锁模闭式挤压新型模具结构。
2.
A new type of structure of closed extrusion dies for fuel injector bodies without flash is presented.
本文给出了喷油器体无飞边闭式挤压新型模具结构。
3) open die extrusion
开式挤压
1.
Maximum and minimum critical rates of deformation in open die extrusion are discussed on the basis of the slip field theory and the upper bound theory of plane state plastic deformation.
采用平面塑性变形的滑移线理论和上限理论对开式挤压成形工艺中的临界最小和临界最大变形率进行了分析计算，给出了挤压模角与临界最小和临界最大变形率的对应关系；根据压杆稳定性理论，给出了挤压坯料的最大长度计算方法，为制订开式挤压成形工艺参数提供了依据。
5) compression mode
挤压模式
1.
Mechanical behavior of magnetorheological fluid under compression mode
基于挤压模式下磁流变液力学行为的实验研究
6) open-die cold extrusion
开式冷挤压
1.
Research on experiment of size prediction of thick-walled tube without mandrel by open-die cold extrusion;
厚壁管件无芯棒开式冷挤压尺寸预测的实验研究
2.
Research on improving prediction accuracy of maximum reduction by open-die cold extrusion;
提高开式冷挤压极限变形程度预测精度方法的研究
3.
Analysis of process parameter of open-die cold extrusion with upper-bound method
开式冷挤压工艺参数的上限法分析与实验研究
补充资料：冲击挤压(见冷挤压)
冲击挤压(见冷挤压)
impact extrusion
ehongji jiya冲击挤压(impaet extrusion)见冷挤压。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条