1) Ohmic start-up
欧姆电流启动
2) starting current
启动电流
1.
The equipment applied enclosed cycle and current limited to control starting current.
该设备采用闭环限流控制适时检测跟踪并控制启动电流,设备性能稳定可靠,结构简单、维护方便、启动电流可按工艺工况随机进行无级调整;克服了电抗器、自耦变压器适应性差的缺点。
2.
Firstly, the relation between coil turns and minimal starting current is revealed, and the measures to improve the minimal starting current are presented.
先对特制线圈绕线匝数与最小启动电流间的关系进行研究,提出改善最小启动电流的方法;然后设计并实现了两种方案所对应的硬件电路,比较了两种方案的优缺点。
3.
The new approach,which checks differential protection connection using electromotor starting current,is simple and reliable,and easy to be coordinated with installation schedule.
而利用电动机启动电流检验差动保护接线的新方法,简便可靠,容易与现场安装施工进度相协调。
3) startup current
启动电流
1.
The results of theoretical analysis and simulative experiment showed that the method mentioned in paper can accurately distinguish the startup current and the short-circuit current and was simple.
可利用启动电流和短路电流的这一特点来识别两者,以避免保护的误动。
2.
Experimental results show that the scheme can be easily applied to control a three-level pulse width modulation rectifier without power source voltage sensors,and that the startup current is reduced about 50% by the soft-start process.
实验结果表明,该方法能够实现三电平脉宽调制整流器的无网侧电压传感器控制,并能降低系统启动电流约50%。
4) ohmic resistance
欧姆电阻，直流电阻
5) Ohmic drive
欧姆驱动
6) ohmically heated discharge
欧姆放电
1.
The ratio of the bootstrap current to the total plasma current is analyzed before and after wall conditionings of the ohmically heated discharges in the HT-7 tokamak.
分析了HT-7托卡马克壁处理前后欧姆放电时的自举电流占总等离子体电流比例的变化情况。
补充资料：标准冲击电流波形(见冲击电流发生器)
标准冲击电流波形(见冲击电流发生器)
standard impulse current wave form
blaozhun ehonglld}0n4一u box]ng标准冲击电流波形(standard impulse currentwave form)见冲击电流发生器。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条