1) wide and thick slab continuous casting
宽厚板坯连铸
1.
A water model of a wide and thick slab continuous casting tundish was established to study the effect of different control devices on the characteristics of fluid flow.
通过宽厚板坯连铸中间包水模实验,研究了不同控流装置对中间包内流动特性的影响。
2) wide and thick slab continuous casting tundish
宽厚板坯连铸中间罐
1.
Characteristics analysis of molten steel flow in a wide and thick slab continuous casting tundish;
宽厚板坯连铸中间罐内钢液流动特性分析
3) thick slab concasting
连铸厚板坯
5) wide slab continuous casting
宽板坯连铸
1.
Based on the150 mm×(1 600～3 250) mm wide slab caster mold as investigating object,the level fluctuation in the mold of the wide slab continuous casting was simulated by a three dimensional finite-volume model(VOF) which had been formulated according to the commercial code ANSYS CFX10.
以150 mm×(1600~3 250)mm宽板坯连铸结晶器为研究对象,利用大型商业软件ANSYS CFX10。
2.
Based on four sectional width of wide slab continuous casting mold of a steelmaking plant in China,a water model with 1∶1 ratio was established,and according to the orthogonal test method,the influence of the different factors on the flow in the mold was studied,including hole numbers of SEN,argon gas injection of nozzle,immersion depth of nozzle,casting speed and sectional size of mold.
结合国内某钢厂宽板坯连铸结晶器的4种断面宽度,建立1∶1水模型,并结合正交试验方法,研究了浸入式水口的吐出孔数、水口吹气量、水口浸入深度、拉速和结晶器断面宽度等不同因素对结晶器流场的影响,得到了4种宽板坯连铸结晶器的最佳工况条件。
6) wide slab caster
宽板坯连铸
1.
Water model experiments on surface flow fluctuation patterns in wide slab caster mold;
宽板坯连铸结晶器内液面波动的水模型研究
2.
Taking 150 mm×1 600～3 250 mm wide slab caster mold as an investigating object,the fluid flow in the mold of wide slab continuous casting is simulated by a three dimensional finite-volume model,which has been formulated according to the commercial code ANSYS CFX10.
以150 mm×1 600~3 250 mm宽板坯连铸结晶器为研究对象,利用大型商业软件ANSYSCFX10。
补充资料：宽厚
①宽而厚：～的胸膛。②（待人）宽容厚道。③（声音）浑厚：唱腔高亢～。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条