1) original microstructures
原始微观组织
2) original microstructure
原始组织
1.
With quenching and hot rolling pretreatment,25MnV steel's hardness and strength after zero time holding quenching in different original microstructures were researched by orthogonal regressive principle,and its microstructure was analyzed too.
采用正交组合回归设计试验方法,分别以淬火和热轧为预处理工艺,研究了不同原始组织条件下25MnV钢“零保温”淬火后的强度和硬度,并进行了组织分析。
3) original structure
原始组织
1.
By means of high temperature microscope,graphite precipitation from T10A steel specimens with 4 kinds of original structures has been dynamicly observed when heated and cooled in vacuum.
用高温金相显微镜动态观察4种原始组织的T10A钢试样在真空加热及冷却时的石墨析出现象。
2.
The results show that the original structure affects the microstructural evolution process in a great extent.
研究了控制浇注法制备A356合金半固态枝晶衍变规律,结果表明:原始显微结构对枝晶半固态衍变具有较大影响,对于原始组织粗大的树枝晶合金,即使经过长时间的保温,初生α相仍为枝晶网状结构;而原始组织细小的等轴晶迅速转变为球状结构。
3.
To observe the austenitic grain growth dynamically of T10A with different original structures during heating in vacuum.
试验结果表明 ,原始组织为片状珠光体或非平衡组织 (如下贝氏体或马氏体 )比粒状珠光体形成的奥氏体晶粒具有更强烈的长大趋势 ,前三者的急剧长大温度在 10 0 0℃左右 ,后者在 110 0℃左
4) microstructure
[英]['maikrəu,strʌktʃə] [美]['maɪkro,strʌktʃɚ]
微观组织
1.
Acicular ferrite microstructure of weld metal for low-alloy steel;
低合金钢焊缝的针状铁素体微观组织
2.
Effects of Ce and Sn on Microstructure of AZ91 Magnesium Alloy;
Ce、Sn对AZ91合金微观组织的影响
3.
Preorm optimal design and experimental study on the microstructure in forging process;
面向微观组织优化的锻造工艺预成形优化设计及实验研究
5) Microstructures
微观组织
1.
Effect of strain rate on flow stresses and microstructures of titanium alloy TC11 alloy;
应变速率对TC11钛合金流动应力和微观组织的影响
2.
Effects of minor manganese addition on microstructures and tensile properties of Al-Mg-Si alloys;
微量Mn对Al-Mg-Si合金微观组织与拉伸性能的影响
3.
Mechanical properties,microstructures and fracture appearance of the sand-cast samples of ZL210A alloy solution-treated at 545 ℃ and 555 ℃ respectively were analyzed.
通过对ZL210A合金砂型试样进行545℃固溶和555℃固溶处理,分析不同固溶温度处理试样的力学性能、微观组织和断口形貌,探讨了不同固溶温度对合金砂型试样性能和组织的影响。
6) micro structure
微观组织
1.
The tests on the micro structure and mechanical performance of Incoloy 800H alloy which has been in high-temperature and high-pressure environment service of H_2-presence for 100,000 hours and comparison of the test results with characteristics of hydrogen induced cracking of austenitic steel ha.
文章通过试验研究了高温高压临氢环境下、服役约100 kh的Incoloy 800H合金钢的微观组织和力学性能,并将试验结果与氢致奥氏体不锈钢损伤典型特征比较,发现长期服役在高温高压临氢工况下,氢致Incoloy 800H力学性能下降和微观组织损伤轻微,即Incoloy 800H合金钢抗氢损伤性能优良。
2.
The influence to micro structure of laser cladding layer by laser cladding craft parameters is studied, and the micro hardness of laser cladding layer and substrate is tested.
研究了工艺参数对激光熔覆层微观组织的影响,测试了熔覆层和基材的显微硬度,获得了无裂纹、孔洞等缺陷的熔覆层。
补充资料：原始
①最初的；第一手的：原始记录｜原始材料。②最古老的；未开发的：原始社会｜原始森林｜原始时代｜原始宗教。③推究本始：原始要终。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条