1) voltage divider resistance
分压电阻
2) resistive subdivision
电阻分压
1.
The circuit adopts the resistive subdivision so as to adjust the ratio of the resistors for getting the reference voltage.
该电路的放大器使用体驱动技术,提高了输入电压共模范围;基准电路采用电阻分压结构,通过调节电阻之间的比值获得所需要的基准电压;并采用TSMC 0。
3) resistance divider
电阻分压器
1.
Performance of resistance divider and measurement of high-voltage nanosecond double exponential pulse;
电阻分压器性能与高压纳秒双指数脉冲的测量
2.
In order to avoid spurious parameters of pulse divider, an optimum design was performed for the structure parameters of a novel aqueous-electrolyte resistance divider by using the complex method of the nonlinear programming problems.
为了避免脉冲分压器的杂散参数的影响,笔者采用非线性规划的复合形法对按传输线原理设计的电解液电阻分压器的结构参数进行了优化设计,通过分析优化结果得出:在满足测量精度和耐压的情况下,分压器的尺寸越小越好;该型电阻分压器由于其自身结构的特点,要求硫酸铜液电阻的阻值尽量小;对该型电阻分压器进行优化设计时应综合考虑测量的要求。
3.
A new type of resistance divider used for high voltage pulse measurement has been developed based on the theory of transmission line.
运用传输线原理设计了一种测量高压快脉冲用的新型电阻分压器。
4) resistor divider
电阻分压器
1.
A water resistor divider for measure the output voltage of PTS Marx-bank had been designed.
为了测量PTS单路样机Marx发生器的输出电压,设计并标定了一个二级分压的水电阻分压器。
5) resistive divider
电阻分压器
1.
A new counterbalance way is researched,and the structure of new resistive divider is designed in this paper.
电阻分压器对地分布电容是影响其性能的关键因素。
2.
Aiming at the influence of stray inductance and capacitance on the performance of resistive divider,a lumped-parameter circuit model of resistive divider including inductance,capacitance and resistor is established.
针对纵向杂散电容和对地杂散电容对电阻分压器性能的影响,建立了一个包含电感、电容和电阻元件在内的分压器集中参数模型。
6) resistive voltage divider
电阻分压器
1.
The voltage sensor in transformer is based on the resistive voltage divider;also this sensor is non-saturable and linear over the whole measuring range.
介绍了电阻分压器传感电压的电阻式电压互感器;它在整个测量范围内无饱和畸变、线性好而且体积小、结构紧凑,便于测量和控制系统小型化。
2.
A new method of compensating for resistive voltage dividers is proposed in this paper.
按这种方法设计的兆估级纳秒脉冲电阻分压器自身的方法响应上升时间约为1ns。
补充资料：分压电阻
与某一电路串联的导体的电阻。在总电压不变的情况下，在某一电路上串联一个分压电阻，将能起分压的作用，一部分电压将降在分压电阻上，使该部分电路两端的电压减小。分压电阻的阻值越大，分压作用越明显。在电流计线圈上串联一个高阻值的分压电阻，就能把电流计改装成伏特表，量度较大的电压。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条