1) Ignition-detonation time
点火-起爆时间
2) firing and initiation
点火与起爆
4) ignition time
点火时间
1.
The article concentrates on the ignition time under different conditions such as the radiation flux,the distance between the sample and the radiation source and the sample obliquity.
利用正交化实验方法,在火灾早期特性实验台上进行了一系列实验,实验过程采用摄像机进行拍摄,对摄像结果进行分析后,得出不同工况条件下木材的点火时间(诸工况包括辐射源功率、样品与辐射源距离和样品倾角等),从实验角度进行初步分析后,再利用数值分析理论计算出它与各种工况的函数关系。
2.
5W laser diode Ignition tests are performed on pyrotechnic material Zr/KClO 4 The relation between the sensitivity of Zr/KClO 4 and its parameters such as mass ratio and density are investigated by determining the ignition time.
通过对点火时间的测定，研究了Ｚｒ／ＫＣｌＯ４的激光感度与配比、密度等参数的关系。
3.
By using of mathematical models, derived leak caused by the loss of hose is simulated and the leakage concentration with the changes of time is concluded, impact of the ignition time to the indoor gas accident is analyzed,and preventive measures, such as elimination and control of fire sources,prevention to the formation of explosive mixtures and optimal alloc.
分析了点火时间对室内燃气事故的影响,提出了控制消除引火源、防止形成爆炸性混合物以及燃气设施的优化配置等相应预防措施。
5) firing time
点火时间
1.
Relationship between the firing time and the input energy/voltage in a semiconductor bridge(SCB) was studied.
研究半导体桥的点火时间同输入能量以及电压的关系 。
6) initiating detonation system
起爆点火系统
1.
Based on detailed analysis of the basic theory of detonation wave and operating principle of pulse detonation engine (PDE) as well as the existing ignition system of aero-engines and motors, a design approach for semiconductor high energy ignition system is put forward according to the PDE′ requirements of initiating detonation system for adjustable ignition energy and changeable spark frequency.
设计的倍压整流、半波整流和直流供电的脉冲爆震发动机起爆点火系统实现了点火能量和火花放电频率的控制。
补充资料：点火
①引着火；使燃料开始燃烧：上午七点整，火箭发动机～。②比喻挑起是非，制造事端：煽风～。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条