1) burst current density
爆发电流密度
1.
The tested results show that,for the round shape bridge foil,the burst current density is maximum,the initiating voltage at 50% firing probability of HNS-IV is minimum,the availability of energy is improved further and the firing energy is reduced.
试验结果表明圆形桥箔的爆发电流密度最大,起爆HNS-IV的50%起爆电压最低,爆炸箔起爆器(EFI)选用圆形爆炸箔桥箔可以进一步提高能量利用率,降低发火能量。
2) Burst current
爆发电流
1.
For the exploding foil of Au, Cu, Au-Pt and Al, the burst current and dynamic resistance during the explosion were calculated.
为了研究金属电爆炸特征,编制了计算金属导体电爆炸放电回路的程序,对桥箔爆炸物理过程进行了数值计算,得到了金、铜、金-铂合金及铝四种金属桥箔爆炸的爆发电流和动态电阻。
3) emission current density
发射电流密度
1.
The impulse emission current density is 25.
XRD,TG-DSC分析表明:液相共沉淀法最佳合成温度为1100℃,比高温固相反应法的合成温度降低了150℃;产物主晶相为Ba5CaAl4O12;合成的盐制备成阴极,化学液相共沉淀法的脉冲发射电流密度25。
4) emitted current densities
电流发射密度
5) current density
电流密度
1.
Effect of current density on performances of deposit in low-temperature iron plating process;
低温镀铁时电流密度对镀层性能的影响
2.
Research and application on current density of ion exchange membrane electrolyzer;
离子膜电槽电流密度的研究及应用
3.
Effects of anode current density on micro-arc oxidation ceramic coating of aluminum alloy;
阳极电流密度对铝合金微弧氧化陶瓷膜的影响
6) electrical current density
电流密度
1.
The influences of electrical current density of Joule heating treatment on GMI effects of amorphous Co_(68.
本文研究了焦耳处理工艺的处理电流密度对Co68。
补充资料：标准冲击电流波形(见冲击电流发生器)
标准冲击电流波形(见冲击电流发生器)
standard impulse current wave form
blaozhun ehonglld}0n4一u box]ng标准冲击电流波形(standard impulse currentwave form)见冲击电流发生器。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条