1) temperature matching method
温度匹配法
1.
Both the Mark VI temperature matching method and the attempering water method are described,while their advantages,shortages as well as specific operating procedures presented.
介绍了Mark VI温度匹配法及减温水法2种滑参数停机的方法、优缺点和操作步骤。
2) temperature matching
温度匹配
1.
The outstanding characteristic and superiority of non-azeotropic mixtures is their capability of temperature matching with the secondary heat transfer fluid (SHTF).
非共沸混合工质的一大特点和优势就是能够通过相变过程中的温度滑移实现和变温热源的温度匹配。
2.
The paper introduces the purpose and principle of temperature matching of S109FA unit,analyzes load rejection phenomena of turbine during cold-state start-up,and optimized start-up procedure.
介绍了S109FA机组温度匹配的目的及原理;分析了机组在冷态开机过程中的汽机卸载现象及优化开机程序;最后,介绍了温度匹配法滑参数停机的目的、详细操作步骤、注意事项等。
3.
Improvements for different start up modes and their economic analyses were made,such as: start up in advance,shorten the time required to match the high pressure casing inlet steam parameters,not put the" temperature matching" to use after synchronization but later when steam leads into the high pressure casing and early withdraw the "temperature matching" etc.
针对不同条件下启动方式的改进,如提前启动;缩短满足高压缸进汽参数的时间;并网后不投入"温度匹配",而在高压缸进汽时再投入"温度匹配";提早退出"温度匹配"等进行了经济性分析。
4) density matching
密度匹配法
5) temperature match curing
温度匹配养护
1.
The influence of the addition of fly ash on the compressive strength of concrete was studied under the temperature match curing conditions.
通过工程实例研究了不同养护条件对大掺量粉煤灰混凝土强度发展的影响,发现温度匹配养护下7 d的抗压强度远高于在标准养护和同条件养护下的抗压强度。
6) temperature tuning bandwidth
温度匹配带宽
补充资料：铂电阻温度表(见电阻温度表)
铂电阻温度表(见电阻温度表)
表。bod旧nZu wendubiao铂电阻温度表见电阻温
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条