1.
Their preform moulds could be 2-cavity based and use a hot plate or hot runner design.
模具有用两腔的，采用热板/热流道设计。
2.
The Research on Application of Thermal Balance and Temperature Control for Hot Runner System;
热流道热平衡及测控系统的应用研究
3.
Thermal balance and finite element analysis of temperature field for hot runner plate
热流道板的热平衡及温度场的有限元分析
4.
The Study on Design of Stack Mold with Hot Runner System and Its Functions;
叠式热流道模具设计及其功能的研究
5.
The design on hot runner control system based on single-chip
应用单片机的热流道控制系统的设计
6.
Improvement of the Hot Runner Injection Mold for CBP12 Water Tank Cover
CBP12水箱面罩注射模热流道改进
7.
Microfluidic Flow and Heat Transfer in Microchannel Heat Sinks;
微管道换热器内微流体的流动与换热
8.
Superheat decreases as the channel narrows at low heat flux, but it inverts at high heat flux.
在较低热流密度下,窄通道强化传热;
9.
Investigation on Flow and Heat Transfer Characteristics in a Micro-Channel Heat Sink;
微通道热沉内流体流动与传热特性研究
10.
Investigation on Flow Characteristics and Heat Transfer in a Manifold Micro-Channel Heat Sink;
歧管式微通道热沉内流体流动与传热特性研究
11.
Numerical Simulation of Fluid Flow and Heat Transfer in Microchannel Heat-Sink;
微通道热沉内流体流动与传热的数值模拟
12.
Numerical Study of Convective Heat Transfer in the Dimpled Channel;
丁胞流道内流动传热的数值模拟研究
13.
Analyses on Heat Transfer Characteristics of Single-Phase Turbulent Flow in Narrow Annular Channel
环形窄缝通道湍流流动换热特性分析
14.
Experimental Investigation of Convection Condensation Heat Transfer in Heat Pipe Heat Exchanger for Flue Gas Heat Recovery Use;
用于烟道气热回收的热管换热器中对流冷凝传热实验研究
15.
Experimental Study of Mixed and Forced Convection from A Small Heat to Liquid Flow in Vertical Narrow Channels
窄通道内小传热面的混合与受迫对流换热研究
16.
CONVECTIVE HEAT TRANSFER IN TORTUOUS HEAT RADIATOR FILLED WITH OPEN-CELL COPPER FOAM
泡沫铜填充曲折槽道散热器内对流换热研究
17.
Study of Natural Convection of Closed triangle channel heat pipe
封闭三角形通道内热管的自然对流换热研究
18.
A Numerical Study of Heat Transfer in Round Silicon Microchannel Heat Sinks
圆形微通道热沉流动换热特性的数值研究