1.
The tesile fracture is mixture of quasicleavage and touph dimple.
拉伸断口为韧窝和准解理混合断裂。
2.
Analysis on the Reason for Tensile Fracture Stratification of Q345 Plate
Q345钢板拉伸断口分层原因分析
3.
The fracture of composites assumes toughness dimple.
复合材料的拉伸断口为解理与韧窝混合断裂.
4.
The microstructure and tensile fracture surface of the Q235 steel has been investigated by TEM and SEM.
应用TEM和SEM观察钢的微观组织结构及拉伸断口。
5.
Study on Lamination Cracks of Low-alloy High Strength Steel Plat
低合金高强度钢板拉伸断口分层机理分析研究
6.
Tensile Fracture Morphology of As-cast 7005 Aluminum Alloy Produced by Electrolytic Liquid Al
电解铝液制备的7005铝合金铸态拉伸断口分析
7.
Causes of Laminated Fracture under Tensile Test for A131GrAH36 Steel Plate and Improving Measures
A131GrAH36船板钢拉伸断口分层原因及改善措施
8.
Microstructures and Tensile Fracture Characteristics of Spray Deposited Al-Zn-Mg-Cu Alloy Hot-Rolled Plates
喷射成形Al-Zn-Mg-Cu合金热轧板材的显微组织及拉伸断口分析
9.
By way of suitable heat treatment, the tensile fracture morphology changes from brittle intercrystalline fracture to dimple fracture, so the strength and ductility of the alloy is increased.
采用适当的热处理工艺可使合金强韧化 ,拉伸断口由脆性的沿晶断裂变为韧窝状断裂。
10.
INTERLAMINAR TENSILE RUPTURE AND FRACTURE ANALYSIS FOR CF/EPOXY MATERIALS
碳/环氧复合材料层间拉伸断裂与断口分析
11.
The Unified Model and Fracture Criterion of Annular Breach Bar in Tension
环形缺口拉伸圆杆的统一模型和断裂准则
12.
The Reason Analysis for Abnormal Fracture in Cold Bending and Stretching of 510L Automobile Crossbeam Steel
510L汽车大梁钢冷弯、拉伸异常断口原因分析
13.
Analysis of Cause for Layered Fracture Occurring during Tensile Test of Q390E Steel Plate
Q390E钢板拉伸试验试样断口分层原因分析
14.
SINGLE NOTCHED TENSILE FRACTURE OF PA6/CaCO_3 COMPOSITE
PA6/CaCO_3复合材料的单边缺口拉伸断裂研究
15.
Analysis on the Cause of Fracture Lamination during Tensile Test of Q345B Medium Plate
Q345B中厚板拉伸试验断口分层的原因分析
16.
breaking tensile test of rope
钢丝绳破断拉伸试验
17.
Glass always fails in tension.
玻璃总是在拉伸中断裂。
18.
Influencing Factors of Fracture Layered for Tensile Test Sample of High Strength Ship Plate Steel
高强度船体用结构钢拉伸试验样断口分层的影响因素