1.
Study of Vacuum Heat Treatment Technology on CrWMn Thread Rolling Mould
CrWMn钢滚丝模真空热处理工艺研究
2.
Cause Analysis for Early Failure of Steel Cr12MoV Thread Rolling Die and Its Countermeasure
Cr12MoV钢滚丝模早期失效原因分析与对策
3.
Austempering process of Cr12MoV steel thread rolling die
Cr12MoV钢滚丝模等温淬火工艺
4.
Injection mould with ball screw stripping and ball bearing and ta-pered wedge fixed-distance pull off mechanism
带滚珠丝杠脱模及滚珠斜楔拉模定距装置的注射模
5.
Modal analysis on gear of electronic servomechanism based on ball guide screw
滚珠丝杠电动伺服机构齿轮的模态分析
6.
Research on Modeling and Control of Long Range Nanometer Positioning System Based on Ballscrew;
基于滚珠丝杠的大行程纳米定位系统建模和控制技术研究
7.
Modeling and Simulation of Large Pitch Ball Screw Nut Formation Grinding
大导程滚珠丝杠副螺母成型磨削加工建模与仿真
8.
DYNAMIC ANALYSIS AND SIMULATION OF A RE-CIRCULATION MECHANISM IN BALL SCREW
滚珠丝杠副滚珠循环系统的动力学研究和仿真
9.
Study on Ball's Contact Stress in High-load Ball Screw
大负荷滚珠丝杠副中滚珠接触应力研究
10.
The Relation between Technological Parameter of Drum-Type Cut-tobacco Drier and the Quality of Dried Cut tobacco
滚筒式烘丝机工艺参数与烘后叶丝质量的关系
11.
glass ,figure-rolled, non-wired, unworked
滚花玻璃板材,加金属丝,未加工
12.
ROSE： You're distracting me. Go away!
露丝：你在分散我的注意力，滚开！
13.
Threads and profiles are stronger, consistently accurate and there is no swarf.
滚丝轧辊方法更有力，精度稳定，无屑。
14.
Design and Research of a New Ball Screw Shaft Measurement System;
新型滚珠丝杠测量系统的设计与研究
15.
Study on the Wire Rope Enwinding System for the Roller in ZJ70D Drilling Rig;
ZJ70D钻机滚筒钢丝绳缠绕系统研究
16.
The Design of Control System for Hydraulic Thread Rolling Machine Based on FX-PLC
基于PLC的液动滚丝机控制系统设计
17.
Hybrid Machining Mechanism of Roll-Indent-Chipping in Multi-wire Sawing Process
多丝切割的“滚-刻-削”混合加工机理
18.
Parametrization design of ball screw based on Pro/E
基于Pro/E的滚珠丝杠参数化设计