1.
Influence of Curing Temperature on Performance of Epoxy Thermosets
固化温度对环氧树脂固化物性能的影响
2.
Typical cure temperatures range from 125 to 175℃.
典型的固化温度范围从125～175℃。
3.
When curing temperature below glassy temperature of adhesive coating, bonding strength is reduce with curing extent increase.
固化温度低于胶层的玻璃化温度时，粘接强度随着固化程度的提高而降低。
4.
The Effect of PI Curing Temperature and Rubbing Intensity on STN-LCD Cell with TOP Coating Inside
PI固化温度及摩擦强度对涂TOP/STN-LCD的影响
5.
Shrinkage stress was found to increase linearly with cure temperature.
我们发现收缩应力随固化温度直线增加。
6.
Effects of curing temperature and filler content on the performance of epoxy adhesive for restoration of cultural relic
固化温度及填料对文物环氧胶粘剂性能的影响
7.
Design of Inspecting and Controlling Temperature of Micro-wave Solidification Used in Glue-repair
用于胶接抢修的微波固化温度监控系统设计
8.
Again, if there is excessive relative sliding the fluid will become too hot to solidify.
液体温度太高以致也不能固化。
9.
Research on Solid-state Infiltrated B_4C for TC4 at Different Temperatures
TC4在不同温度下固态渗碳化硼研究
10.
The rate of curing and consequently the rate of heat generation increase with the temperature.
固化速度，因而还有放热速度，都随温度而增加。
11.
The influnce of temperature and curing light units on the microhardness of composite resin
不同温度及不同光固化灯对光固化复合树脂硬度的影响
12.
Microtructure Evolution of Al-In and Cu-Pb Monotectic Alloys Directionally Solidified in High Temperature Gradient;
高温度梯度定向凝固Al-In和Cu-Pb合金组织演化
13.
Research on Waste Mud Solidification Processing Technology in Different Salinity and Temperature
不同盐度、温度下的废泥浆固化处理技术
14.
Under proper conditions of humidity, they hatch in approximately 1 month.
在固有的温度条件下，虫卵约在一个月内孵化。
15.
The time-temperature equivalence of the adhesive is confirmed.
同时胶粘剂的固化时间和温度存在等效性关系。
16.
Too hot machines means hardening of the rubber in the machine.
成型机温度过高极易造成液胶在机内过早固化。
17.
The Gasification and Incineration Process Control of Industrial Solid Waste;
工业固体废弃物干馏气化焚烧的温度控制过程
18.
Simulating Analysis on Thermal Stress during the Process of Enhancing Seepage Resistance of an Aging Concrete Dam;
老化混凝土坝防渗加固施工温度应力仿真分析