1.
Influence of Deformation Rate on Strain-Induced Phase Transition of 2205 Duplex Stainless Steel
变形速率对2205双相不锈钢形变诱导相变的影响
2.
Study on the Steady-state Creep Deformation Rate for High-temperature Weld Structures;
高温焊接结构稳态蠕变变形速率的研究
3.
The influence of different deformation temperature and different deformation rate on SUS316L stainless steel flow and mircostructure
不同变形温度和变形速率对SUS316L不锈钢流变应力及金相组织的影响
4.
Based on the deformation rating method, this paper discusses the study of deformation monitoring control indices for the Three Gorges Permanent Ship Lock Slope.
本文采用变形速率法,对三峡永久船闸变形监控指标进行探索。
5.
Effect of Strain Rate on Deformation Induced Ferrite Transformation of Q235 Steel
应变速率对Q235钢形变诱导铁素体相变的影响
6.
Influence of Strain Rate on Grain Refinement by Plastic Deforming;
应变速率对强塑性变形晶粒细化的影响
7.
Deformation microstructure of AZ31B magnesium alloy under high strain rate compression
高应变速率下AZ31B镁合金的压缩变形组织
8.
Effect of Strain Rate on Deformation Behavior in α+β Phase Field of Titanium Alloy TC11
应变速率对TC11钛合金α+β相区变形行为的影响
9.
Experimental Research on Time-Varying Regularity of Deformed Reinforcement Corrosion Rate in Concrete
混凝土内变形钢筋锈蚀速率时变规律试验研究
10.
Effect of Temperature on Deformation Behavior and Microstructures at Low Strain Rate of Titanium Alloy TC11
变形温度对TC11合金低应变速率下的变形行为及组织的影响
11.
Deformation promotes the growth of ferrite grains, the growing rate of ferrite in the early stage of DEFT was calculated.
形变强化相变铁素体晶粒转变初期的长大速率随应变速率的增加而增大.
12.
Study Relations between the Earth Filled Speed of Embankment and the Soft Soil Ground Distortion.;
路堤填土速率与软土地基变形关系的研究
13.
Model Analysis on Change Rate of Horizontal Acceleration in Line Shape Comfortableness of Road
道路线形舒适性中横向加速度变化率模型分析
14.
The flow stress can be described by temperature-compensated strain rate, the so-called Zener-Hollomon parameter.
3．利用7055铝合金高温塑性变形时稳态流变应力σ、应变速率(?)
15.
Effect of Strain Rate on the Tensile Properties of Mg-Zn-Nd Alloy;
应变速率对挤压变形Mg-Zn-Nd合金拉伸性能的影响
16.
Improvement on the Severe Plastic Deformation Method and Investigation on the Mechanical Properties of Ultra-Fine Grained Aluminum;
强塑性变形方法的改进及超细晶纯铝应变速率敏感性研究
17.
Effect of strain rate on dynamic recrystallization microstructures of β hot process for TA15 titanium alloy
应变速率对TA15钛合金β热变形动态再结晶组织的影响
18.
The hot deformation behavior of7055 aluminum alloy compressed under high temperature can be represented by stress strain rate equation.
可用应力应变速率方程来描述7055铝合金高温压缩变形时的热变形行为。