1.
The results showed that the tensile strength, flexural strength and flexural modulus increased obviously with increase of amount of Mica.
结果表明,复合材料的拉伸强度、曲强度和弯曲模量随着云母用量的增加而提高。
2.
The Construction Design of the Bending Die for Improving the Surface Finish of Parts;
提高工件表面质量的弯曲模结构设计
3.
Bending Calculation of Bimodulous Circular Plate under Concentrated Loads
集中载荷作用下双模量圆板弯曲计算
4.
Fiber Loop Ring-down Spectroscopy(FLRDS) in Multimode Fiber Bending Loss Measurement
应用FLRDS技术测量多模光纤的弯曲损耗
5.
Measurement of Elastic Modulus of Microstructure by Microjet Driving Microbending Test Method
微射流驱动弯曲测试法测量微结构的弹性模量
6.
FEM Simulation of Bending Deformation and Research on Quality Controlling for Truck Lengthwise Beam;
车架纵梁弯曲成形模拟分析及质量控制的研究
7.
Vibration Analysis of Kirchhoff Plates by the Nonconforming Element Method with Mass-Lumping;
薄板弯曲问题的集中质量非协调有限元模拟
8.
Bending Test of Young's Modulus of Crystalline Silicon Nano-Beam
单晶硅纳米梁杨氏模量的弯曲测试(英文)
9.
The bending forming of precision progressive die based on energy conservation and numerical simulation
基于能量守恒和数值模拟的精密级进模弯曲成形研究
10.
Profile design for stretch bending die of extrusions considering springback
考虑弯曲回弹的拉弯模外形设计方法
11.
Finite Element Simulation for Laser Curve Forming of Sheet Metals;
板料激光曲线弯曲成形的有限元模拟
12.
"The pin gauges are used to measure the whole distance, the pitch diameter of the thread, etc. Especially, they are suitable for curved groove width measurement."
针规适用于机械加工中孔径、孔距、内螺纹小径的测量,特别适于弯曲槽宽及模具尺寸的测量。
13.
Study of Springback for Design of the Tool in Big Sheet Metal Forming;
大型板材弯曲模具设计中补偿弯曲回弹变形的研究
14.
Test method for flexivity constant of thermostat metals
GB/T5985-1986热双金属弯曲常数测量方法
15.
The branches were bending with the weight of the fruit.
树枝被果实的重量压得弯曲了。
16.
determination of flexural properties of rigid plastics
硬质塑料弯曲度测量方法
17.
Determination of deflection for rigid plastic pipes
GB/T8805-1988硬质塑料管材弯曲度测量方法
18.
These tubes are lightweight, soft and pliable.
这些管子重量轻，柔软易弯曲。