1.
The beams are designed with respect to the bending moment.
梁是按照弯矩设计的。
2.
On the influence of the bending moment waveform disturbance on the pure bending beam flexion
弯矩波形扰动对纯弯梁弯扭屈曲的影响
3.
The Calculatiou of critical load by torsion angle-bending moment matix;
用转角弯矩矩阵确定压杆的临界荷载
4.
The Influence of Cold-Formed Effect to Stress Capacity Performance of Cold-Formed Rectangular Hollow Section Beams;
冷弯效应对冷弯矩形钢管梁受力性能的影响
5.
COMPARATIVE STUDY ON BENDING STRENGTHENING METHOD OF NEGATIVE MOMENT AREA AT BEAM END IN RC FRAME
梁端负弯矩区受弯性能加固方法对比试验研究
6.
Research on the Curves Versus Moment Hysteretic Behavior of Thin-walled Cold-formed Steel Beams
冷弯薄壁型钢梁的弯矩-曲率滞回性能试验研究
7.
Calculation for Cracking Moment of SRC Flexural Member
型钢混凝土受弯构件开裂弯矩的计算初探
8.
Study of plastic limit load of the combined fittings of double elbows under in-plane bending moment
面内弯矩下双弯头组合管件的极限载荷研究
9.
Bending moments produced by lift generally have only a small effect on the resultant bending moment.
一般由升力所产生的弯矩对最终的弯矩只有很小的影响。
10.
Torque and Bending Moment in a Shaft with Combined Deformation Measured by Resistance Strain Gauge Method
电阻应变计法测量组合变形轴的扭矩和弯矩
11.
ANALYSIS OF COMPOSITE BENDING MOMENT DIRGRAMS UNDER BENDING AND BENDING DEFORMATON FOR ROUND SHAFT;
关于圆轴含有弯弯组合的合成弯矩图形状的讨论
12.
The actual stress is not proportional to the bending moment.
实际上应力与弯矩不成正比。
13.
amplitude of wave-exited ship bending
波浪引起的船体弯矩幅值
14.
There are many shortcut methods in moment distribution.
在弯矩分配中有很多的简化法。
15.
But the bending moment at the central hinge must vanish.
但在中间铰处，弯矩必定为零。
16.
IDENTIFICATION OF BENDING MOMENT LOADINGS RESULTING IN CRACK DAMAGE OF CLUTCH CASE
导致离合器壳体破裂的弯矩载荷识别
17.
Research on Moment-curvature Hysteretic Relationship of Steel Reinforced Concrete;
型钢混凝土弯矩—曲率滞回关系研究
18.
The Analysis of Moment Magnifier for Reinforced Concrete Arch Bridge;
钢筋混凝土拱桥弯矩增大系数的分析