1.
Permeability Measurement Method of the Glass Mat in VARI Process
真空灌注成型工艺中玻璃纤维毡渗透率的测量
2.
Piping Layout and Pores Formation in VARTM Manufacture Process of Wind Tube Blade
叶片真空灌注工艺管路布置以及孔隙的形成
3.
Numerical Analysis and Simulation of the Vacuum Infusion Moulding Process
真空辅助成型工艺的数值分析与模拟
4.
Material selection and process discussion of vacuum casting in automotive air intake manifold
汽车进气歧管真空注型材料选用和工艺探讨
5.
Construction Technology of Mechanical Impact Pore-forming in the Project of Pouring Pile Foundation
灌注桩基工程机械冲击成孔施工工艺
6.
Effects of Drilling Methods on the Bearing Capacity of Bored Pile
成孔工艺对灌注桩承载力影响的探讨
7.
NEW TECHNOLOGY OF INJECTION MOLDING:GAS-ASSISTED INJECTION MOLDING;
注射成型新工艺:气体辅助注射成型
8.
air isolation process
空气隔离型集成工艺
9.
Resin Vacuum Cast Process and Its Points for Attention
环氧树脂真空浇注工艺过程及注意事项
10.
Construction process of bored concrete pile in pore-forming by drill and dig and analysis for execution effect
钻挖结合成孔灌注桩施工工艺与实施效果分析
11.
THE DEVELOPMENT OF VACUUM ASSISTED RESIN INFUSION(VARI)
真空辅助树脂注射成型(VARI)研究进展
12.
Completed pile working method of bore hole filling pile in the rock area with under-earth mined out layer
有地下采空层的岩石地区钻孔灌注桩成桩工法
13.
The Molding Technological Research of Large-scale Vehicle Plastic Parts
大型汽车用塑件的注射成型工艺研究
14.
Optimization of the Gas-Assisted Injection Molding Process for the Typical Automotive Plastic Parts
典型汽车注塑件的气辅注射成型工艺优化研究
15.
Based CAE Software Investigated the Co-injection Process;
基于CAE平台的共注射成型工艺研究
16.
Study on Feedstock Preparation of Al_2O_3 Ceramic for Injection Molding
注射成型Al_2O_3陶瓷喂料的制备工艺
17.
OPTIMIZATION RESEARCH OF GAS-ASSISTED INJECTION MOLDING PROCESS PARAMETERS
气体辅助注射成型工艺参数优化研究
18.
Influence Analysis of Injection Process Parameters on Sequential Overmolding Injection
注塑工艺参数对双色注射成型影响分析