1.
Measuring and Controlling the Position Error of Bearing Hole in Machining Canular Forked Shaft;
叉头套轴承孔位置误差的测量与控制
2.
The influence of the journal misalignment in bearing bore resulted from crankshaft deformation when it acted by load should be considered in the lubrication analysis of crankshaft bearing.
曲轴轴承的润滑分析应该考虑曲轴受载变形导致轴颈在轴承孔中倾斜的影响；
3.
Design of Roundness Automatic Measuring System for Bearing Hole of Diesel Engine
机车柴油机轴承孔的圆度自动检测系统设计
4.
main bearing aligning gauge
主轴承座孔同轴度检验仪
5.
Analysis of the cooperation with Cork Drum Shaft,Bearing housing and Ball Bearing on the Changcheng Cigarette|machine
长城机水松纸鼓轮轴和轴承座孔与轴承之间配合关系的分析
6.
Measures for improving the concentricity of the bearing s minor hole at the two ends;
提高套筒两端轴承档内孔同轴度的措施
7.
Deformation of Porous Pad of an Aerostatic Porous Thrust Bearing
空气静压多孔质止推轴承多孔质圆板的变形
8.
Internal Bore Processing of Precision Miniature Bearings Based on Spark Grinding
基于电火花磨削的精密微型轴承内孔加工
9.
Relative Factors Affecting Static Performance of Aerostatic Porous Bearings
影响空气静压多孔质轴承静态性能的有关因素
10.
The Study of Oil-impregnated Porous Polyimide Retainers Used for Gyroscope Bearing;
陀螺轴承用多孔含油聚酰亚胺保持架研究
11.
Research on Key Technologies of Partial Porous Externally Pressurized Gas Bearing;
局部多孔质气体静压轴承关键技术的研究
12.
Theoretic and Experimental Investigation on the Aerostatic Porous Bearing
多孔质气体润滑轴承设计理论与实验方法
13.
Investigation of Pressure Distribution of Partial Porous Aerostatic Thrust Bearing
局部多孔质气体静压止推轴承压力分布的研究
14.
Research the Bearing Capacity of Universal-joint Spindle in 170 Piercing Mill Main Transmission System
170穿孔机主传动系统万向接轴承载能力分析
15.
Research on the Dimension Compensation of the Bearing and the Shell Holes Mate with the Temperature Rising
壳体孔与轴承配合的温升尺寸补偿研究
16.
Analysis of the Precision Measure Method for the Bearing Seat Hole Center Distance in the Gear Box
齿轮箱轴承座孔的中心距测量方法精度分析
17.
Determination of contact-angle searching field on high-speed ball bearing in drilling equipment
钻孔设备高速滚珠轴承接触角搜索域的确定
18.
First you need the boring for the shaft, then install the stern tube into the stern frame, next fit the gun-metal or white-metal bush.
首先要镗孔，然后安装尾轴管，接下来装炮铜或白合金制的轴承套，也叫轴承。