1.
Experimental Study on the Durability of Concrete under the Action of Sub-High Temperature Cycles Cooled by Water and Sulfate Attack;
亚高温水淬循环与硫酸盐侵蚀共同作用下混凝土耐久性试验研究
2.
Recovery of Copper from Water Quenched Slag of Copper Smelting by Impoverishment at High Temperature and Flotation
高温贫化-浮选法从炼铜水淬渣中回收铜
3.
Converting drilling mud to cement slurry by using blast furnace slag
用高炉水淬矿渣将泥浆转变成水泥浆
4.
Water Quenching and Tempering Technology Research of 1000MPa Ultra-High Strength Dual-Phase Steel;
1000MPa超高强双相钢水淬及回火工艺研究
5.
A Study on Mechanism of Self-Propagating High-Temperature Synthesis by Combustion front Quenching Technique;
用燃烧波淬熄法对自蔓延高温合成机理的研究
6.
Study of Micro-alloying and Isothermal Quench of Steel Shots With High Toughness
高韧性钢丸的微合金化及等温淬火工艺研究
7.
Influence of Quenching Temperature on Microstructure and Mechanical Properties of Q&P Super-high Strength Steel
超高强Q&P钢淬火温度对组织和性能的影响
8.
Quenching experiment of Al/Mg_2Si composite synthesized with high-temperature self-propagation
自蔓延高温合成Al/Mg_2Si复合材料的淬熄试验
9.
Effect of Quenching Temperature on Mechanical Properties of Ultra High Strength Steel
淬火温度对超高强度钢力学性能的影响
10.
This company endeavors to hardening, normalizing, tempering, high and medium temperature quenching, mesh belt furnace quenching, cementing, time effective freezing and high temperature treatment etc.
本公司是一家致力于从事调质、火、火、中温淬火、带炉淬火、碳、效冰冷及其高温热处理的厂家。
11.
Research on the Relationship between Self-Hardening of Baosteel's Water-QuenchedG ranulated Blast Furnace Slag and Activity
宝钢高炉水淬矿渣自身水硬性和活性的关系
12.
Study on Microstructures and Mechanical Properties of Low-Alloyed High-Carbon Steels by Low-Temperature Isothermal Treatment;
低合金高碳钢低温等温淬火组织和力学性能的研究
13.
06Cr13 Plastic Deformation Characteristics in High-temperature and Microstructure Analysis under Different Quenching Temperature
06Cr13高温塑性变形特性和不同淬火温度下的组织分析
14.
Stove-exhausting gas used to dry the water-chilled dreg from a blast furnace
利用热风炉废烟气干燥高炉水淬渣的实验研究
15.
Whole Quenching in Solution of Tri-nitrate in Water for Butt Welded High Speed Steel Tap
对焊高速钢丝锥的三硝水溶液整体淬火
16.
austemper stressing
等温淬火表面应力;等温淬火前加应力;加工应力等温淬火
17.
The ceramic layer does not crack or flake off when heated to800℃ and then quenched.
将陶瓷内衬复合钢管加热至800℃温，然后水淬，陶瓷层不炸不裂。
18.
The coated strip goes up into cooling tower and is cooled by air blower and water to room temperature.
镀后带钢进入冷却塔,经风冷和水淬槽将其冷却到室温