1.
Application of the Servo Motor in the NC Machine Tool Servo Feed System
数控机床伺服系统中伺服电机的应用
2.
Intelligent Measurement and Control Arithmatic Investigation of NC Machine Tool Servo System;
数控机床伺服系统智能测控算法研究
3.
Application of DSP in the Machine Tools Servo System;
DSP技术在数控机床伺服系统中的应用
4.
Common Faults and Analysis of CNC Machine Tools Servo System
数控机床伺服系统的故障与应对措施
5.
Application of Forecast Control in Servo System of NC Machine Tool
预测控制在数控机床伺服系统中的应用研究
6.
The Optimization of Servo Parameters on CNC
数控机床伺服系统参数优化配置的研究
7.
The Study of Influence of Rigidity of Servo System in NC Machine on Positioning Precision;
数控机床伺服系统刚度对定位精度影响的研究
8.
Analyzing and Solving of the Common Failure of CNC Machine Tool Servo System
数控机床伺服系统的典型故障分析与排除方法
9.
Examples of Common Faults and Analysis of CNC Machine Tools Servo System
数控机床伺服系统常见故障及实例分析
10.
Common Examples of Fault Diagnosis and Maintenance for NC Servo System
数控机床伺服系统常见故障诊断维修实例
11.
Dynamic design of NC machine DC servo system
数控机床直流位置伺服系统动态设计
12.
The Study of CNC Tool Servo Drive System Based on DSP;
基于DSP的数控机床伺服驱动系统研究
13.
The Design and Simulation of AC Servo Control System on NC Machine;
数控机床交流伺服控制系统的设计与仿真
14.
Research on Robust Control for Linear Servo System on CNC;
数控机床直线伺服系统鲁棒控制的研究
15.
Research on Vector Contronl of AC Servo System of CNC System;
数控机床交流伺服系统矢量控制的研究
16.
Study on Backstepping Sliding Mode Control for Linear Servo System of NC Machine Tool
数控机床直线伺服系统反推滑模控制的研究
17.
Permanent Magnet Synchronous Motor Servo System and Its Application in the NC Machine Tools;
永磁同步伺服系统及其在数控机床中的应用
18.
The Research on NC Machine AC Servo Drive System;
数控机床进给用交流伺服驱动系统的研究