1.
Analysis on dynamic characteristics of pressure pump for hydraulic screw down system in cold rolling mill
轧机液压压下系统恒压变量泵动态特征分析
2.
Quadratic Optimal Control on Dynamic Soft-reduction Hydraulic System of Continuous Caster
连铸机动态轻压下液压压下系统的最优二次型控制
3.
Study on Modeling and System Identification of 300 Four-High Rolling Mill;
300四辊轧机压下系统建模及系统辨识的研究
4.
ON TECHNOLOGICAL REMAKING AND DEVELOPMENT OF HYDRAULIC PRESS DOWN SYSTEM OF 1700 TYPE HOT - ROLLING PLANISHER;
1700热轧平整机液压压下系统的技术改造与开发
5.
Study on Modelling and Simulation of Cold Continuous Rolling Mill;
冷连轧机压下系统建模及仿真的研究
6.
Stress Analysis of the Spherical Bearing of Screw Dow System of ?950 Primary Mill
φ950开坯机压下系统球面轴承的受力分析
7.
Study on Higher Level Lubricant Replacement in the First Rolling Mill Pushdown System
初轧机压下系统润滑油品高层次换代试验研究
8.
Study on Technical and Hydraulic System Simulation of Hydraulic Down Coiler Machine;
全液压地下卷取机工艺研究及液压系统仿真
9.
Research on the Key Technology of Underwater Hydraulic System Utilizing Seawater Pressure
基于海水压力的水下液压系统关键技术研究
10.
The Positive Pressure Control of One Layer Basement Pressurization Air Supply System
只负担地下一层的加压送风系统正压值的控制
11.
Introduction on Ballast Water System of 12000 t Lift Capacity Launch Barge
12000t举力下水驳压载系统设计介绍
12.
Research on Control Strategy for Doubly-fed Generation System under Unbalanced Voltage Condition
不平衡电压下双馈发电系统控制策略
13.
Pressure Releasing of Underground Filling System in Hedong Gold Mine
河东金矿井下充填系统压力释放方法
14.
Fiber Grating Water Pressure Sensor and System for Mine
矿井下用光纤光栅水压传感器及系统
15.
AGC SYSTEM FOR COLD STRIP MILL WITH A. C. MOTOR DRIVEN SCREWING DOWN INSTALLATION
冷轧机交流压下条件下的厚度自动控制系统
16.
Computer control of hydraulic screw down system should have a function of rolling force closed circuit control and roll position closed circuit control.
电气控制系统中的液压压下计算机控制系统要实现轧制压力闭环控制和轧辊位置闭环控制
17.
THE MODEL FOR PREDICTING AERODYNAMIC STABILITY IN THE AXIAL COMPRESSION SYSTEMS WITH INLET DYNAMIC TEMPERATURE DISTORTIONS
动态温度畸变下压缩系统稳定性模型研究
18.
Study on Optimization of Power System with Voltage Stability Constraints;
电力系统电压稳定约束下的最优潮流研究