1.
The Position Error Analysis and Improvement of G5800 Diesel Engine Intake Port
G5800柴油机进气道位置偏差分析及改进
2.
Feature-point classification based on position changes of correspondences
基于同名像点位置偏差的特征点分类方法
3.
B.ALL undimensioned features shall be located within a tolerance of .005 from datum zeroo.
所有未注的特征相对于基准零点的位置偏差须在0.005之内.
4.
Estimation of Rotor Zero-position Error for PMSM
永磁同步电动机位置传感器零位偏差估计方法
5.
A deviation from a vertical or horizontal line, plane, position, or direction.
倾角来自垂直或水平线、面、位置或方向的偏差
6.
Each datum, location pins, the number of the clamp sequence, check pin's name, the value of gap and tolerance need mark on checking fixture.
定位面，定位销，夹紧顺序，孔位测量销，模拟块偏置值及公差需有标识。
7.
Developmental and Gender Differences in the Acquisition of Alcohol Conditioned Place Preference in Mice and the Influences of Stress;
小鼠酒精条件性位置偏爱获得的年龄、性别差异以及应激的影响
8.
Relationship Between the Working Positions of Judges and Timists at the Finish in Track and Field Events and Two Eyes Vision Deviation Errors;
论田径终点裁判员及计时员工作位置与两眼视觉偏差的关系
9.
The lateral deviation of a projectile or bomb.
炸弹或射弹的侧位偏差
10.
off-center planeposition indicatio
偏心平面位置显示器
11.
off center plan display
偏中心平面位置显示器
12.
offset-centre plan position indicator
偏心平面位置指示器
13.
off-centered plan position indicator
偏心式平面位置显示器
14.
Geometrical tolerance-Positional tolerancing
GB/T13319-1991形状和位置公差位置度公差
15.
band of position
船位误差带位置线两侧)船位误差带
16.
The degree of difference between the positions of these two poles when seen at various locations is called magnetic declination.
在不同地点所观测到的这两个极位置之间的差异度数，被称为磁偏角。
17.
Being in a position that is away from the center line of the hull of a ship.
舷外的位于偏离船体主线位置的
18.
position of related features
位置公差，关连形体间的位置