1.
It pointed out that the drafting of mule should better use combination drafting and select right proportion of different drafting with different material.
文章指出，走锭细纱机牵伸应尽量采用混合牵伸方法，根据原料变化相应调整牵伸分配。
2.
During the drawing an adhesive is applied by rollers.
在牵伸过程中,通过罗拉施加粘合剂。
3.
A Material Analysis of the Uneven Dyeing of Draft Compound Silk Fabrics of Polyester Fiber;
涤纶牵伸复合丝织物染色不匀的原料分析
4.
Influence of Draft Multiple in Nesting Zone on Comprehensive Performance of Compact Yarn
集聚区牵伸倍数对紧密纱综合性能的影响
5.
Effects of drawing technology on the properties of PTT/PET bi-component filaments
牵伸工艺对PTT/PET复合长丝性能的影响(英文)
6.
Modeling and Simulation of the Powertrain of Traction Synthesize of Hybrid;
牵引力合成式混合动力驱动系统的建模与仿真
7.
"Spinning is the process of drawing out and twisting a mass of cleaned, prepared fibres. Filament yarns generally require less twist than do staple yarns."
纺纱是对纤维集合体牵伸加捻的过程。长丝比短纤维需要的捻度少。
8.
Eight slivers are drawn together to produce the drawn sliver.
在末道并条机上,八根棉条并合在一起被牵伸成熟条。
9.
Manipulation of Stretching,Pulling and Point-pressing of the Neck Combining Traction for Cervical Retroflexion
引颈拔伸指压手法结合牵引改善颈椎反曲的临床研究
10.
The tesile fracture is mixture of quasicleavage and touph dimple.
拉伸断口为韧窝和准解理混合断裂。
11.
Bardenheuer's extension
巴登霍伊厄氏牵伸术
12.
pin drafter
针梳牵伸机, 针梳机
13.
Modern controlled drafting systems use drafts of the order of 30.
新式的牵伸控制系统使用大约30倍牵伸。
14.
The effect of different drawing condition and way on structure of PAN precursor
牵伸条件以及牵伸方式对PAN纤维结构的影响
15.
Process Analysis about the Additional Pressure Bar in the Drafting Zone on the Spinning Frame
细纱机牵伸区附加压力棒牵伸工艺分析
16.
Influence of Back Zone Drafting Multiple on Pressure Bar Drafting in Spinning Front Zone
后区牵伸倍数对细纱前区压力棒牵伸的影响
17.
Research on Hybrid Active Power Filter of Traction Substations and Its Controller;
牵引变电所混合电力滤波器及其控制器的研究
18.
Research on the Powertrain of HEV Terminal Tractor;
串联混合动力码头牵引车驱动系统研究