说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 句库 -> 拉压杆理论
1.
Research on Strut-and-Tie Method and Its Application in Defective Prestressed Concrete Bridges;
拉压杆理论及其在预应力缺陷桥梁中的应用研究
2.
QUANTIFICATION INDEX RESEARCH FOR THE RATIONALITY OF STRUT-AND-TIE MODEL
拉-压杆模型合理性量化评价指标研究
3.
On Nonexistence of Euler's Formula for Stabilization of Compressive Bar
关于压杆稳定欧拉公式实际上不存在的论证
4.
Study on the Buckling of Non-uniform Cross-section Slender Compressive Bar with Centrally Load
变截面细长压杆失稳基本理论的研究
5.
Strut-and-tie Model of Deep Beam Design Under Uniform Distributed Loads
均布荷载下深梁设计的压杆-拉杆模型
6.
Theoretical Research on Large-Span Tensile Spatial Structures Composed of Cables, Bars and Beams;
大型索杆梁张拉空间结构体系的理论研究
7.
Experimental and Analytical Study on Pull-out Resistance of Adhesive Anchors;
粘结型锚杆拉拔承载力的试验与理论分析
8.
Theory and Experiment Research on Active Vibration Control of Piezoelectric Intelligent Boring Bar;
压电智能镗杆振动主动控制的理论与实验研究
9.
SIZE EFFECT ON THE BUCKLING LOADS OF SLENDER COLUMNS BASED ON A MODIFIED COUPLE STRESS THEORY
基于偶应力理论的压杆屈曲载荷的尺寸效应
10.
Design of Reinforced Concrete Deep Beam Based on Strut-and-tie Model;
钢筋混凝土深梁基于压杆—拉杆模型的设计
11.
Analytical model of predigested strut and tie model for shear-wall
基于STM的简化拉压杆剪力墙单元模型
12.
Composite Extrusion Technics and Mould Design of Alumium Alloy Tie Bar
铝合金拉杆复合挤压工艺及模具设计
13.
The classic theory may be divided into Vorousov open section and Wumanski closed section thin-walled bar theory.
经典理论主要可分为符拉索夫开口薄壁理论与乌曼斯基闭口薄壁杆件约束扭转理论。
14.
The Solution of Elasticity Theory with Different Modulus in Tension and Compression and Settlement Calculation of Piles;
拉压模量不同弹性理论解及桩基沉降计算
15.
Theoretical Study on the Control System of the Hydraulic Press Tension Device of Belt Conveyor;
带式输送机液压拉紧装置控制系统的理论研究
16.
Analysis on different modulus in tension and compression for piled rafts
拉压模量不同理论在桩筏基础分析中的应用
17.
Theoretical and Experimental Study on Buckling Behavior of Cut-T Struts Subject to Shear Center Compression;
剖分T型钢剪心压杆屈曲性能的理论与试验研究
18.
Theoretical and Test Studies on Width to Thickness Ratio Limitation of Cut T-shape Web Subject to Axial Compression;
部分T型钢轴压杆腹板宽厚比限值试验与理论的研究