1.
Leakage Cause Analysis and Modification of Cooler for 2# Unit's Upper Guide Bearing at Longtan Hydropower Station
龙滩水电站2号机组上导轴承冷却器漏水原因分析及改造
2.
The carriage is supported on guide shafts.
托架支承在导轴上。
3.
Pilot bearing in crankshaft. The pilot bearing in the crankshaft is usually either a Bushing or a Ball bearing.
曲轴上的导向轴承:曲轴上的导向轴承一般或者是轴瓦,或者是球轴承。
4.
upper center crankshaft bearing
曲轴主轴承上中轴瓦
5.
Remove the lower insert from the bearing cap.
从轴承盖上拆去下轴瓦。
6.
The journal rubs against the bearing surface.
轴颈在轴承面上摩擦。
7.
Remove thrust bearings from rear main bearing carrier.
从后主轴承托架上拆下止推轴承。
8.
Lightly lubricate pilot bearing with Mopar® high temperature bearing grease.
用Mopar®高温轴承黄油轻轻地润滑引导轴承。
9.
Excessive friction in strut upper bearing
支柱上轴承磨损过度
10.
governor upper bush
调速器上部轴承衬套
11.
radial bearing upper drive sub
上部径向轴承传动接头
12.
The influence of the journal misalignment in bearing bore resulted from crankshaft deformation when it acted by load should be considered in the lubrication analysis of crankshaft bearing.
曲轴轴承的润滑分析应该考虑曲轴受载变形导致轴颈在轴承孔中倾斜的影响；
13.
Welds repair of the bush of water flowing diversion bearing of the hydro-generator unit
水轮发电机组水导轴承轴瓦的焊接修复
14.
The Determination of the Critical Technical Supply Pressure of the Rubber Guide Bearing of the Axial Pump
轴流泵橡胶导轴承技术供水临界压力的确定
15.
Shaft Assembly (Male, female, washer, grease….
轴组件（轴，轴套，轴承，油脂。。。）
16.
As lubricated with outside clean water, bearings are of long life.
导轴承由外接清洁水润滑，使用寿命长。
17.
Dynamic Coefficients of Tilting Pad Guide Bea-rings of Hydraulic Turbine Sets, Power Engineering
水电机组可倾瓦导轴承动力特性系数
18.
The Study on the Hybrid High-Temperature Superconducting Magnetic Bearing System;
高温超导混合磁悬浮轴承系统的研究