1.
terminal heating & cooling units
终端加热和冷却单元
2.
Principle and Troubleshooting of FPD Cooling Unit for DSA System
平板DSA的平板冷却单元原理与温度传感器故障维修
3.
Drain cooling system (refer to Group 7, Cooling System).
排干冷却系统（见单元7-冷却系统）。
4.
Renstall the radiator and condenser unit in the vehiclRefer to Group Cooling System for the procedures.
重新安装散热器和冷却器单元到车辆上。程序，见单元7-冷却系统。
5.
Remove serpentine drive belt, refer to Group Cooling.
拆下蛇型驱动皮带，请参阅单元7-冷却。
6.
Fill cooling system (refer to Group 7, Cooling System for the proper procedure).
注入冷却系统（有关正确程序请参阅单元7，冷却系统）。
7.
Install accessary drive belt (refer to Group 7, Cooling).
安装附属的驱动皮带（请参阅单元7，冷却）。
8.
spent fuel cooling system
辐照燃料元件冷却系统
9.
cooling irradiated fuel element
冷却辐照的燃料组元
10.
To read DTC's and to obtain cooling system data, refer to Group 25, Emission Control Systems for proper procedures.
为阅读DTC并获得冷却系统资料，详情请参阅单元25，排放控制系统。
11.
With the heater control unit in the HEAT position, operate engine with coolant tank cap tightene
让加热器控制单元处于HEAT（加热）位置，旋紧冷却剂贮藏箱填压力/排气盖之后操作引擎。
12.
Loosen the accessory drive belt tension and remove the belt from the power steering pump (refer to Group 07, Cooling Systems for proper procedures).
放松辅助驱动皮带，从动力转向泵上拆下皮带（有关程序，请参阅单元07，冷却系统）。
13.
Study on Fundamental and Crucial Technology about the Heat Sink Unit of Laser Thermal Management System Based on Microgrooves Phase-Change Cooling;
微槽群相变冷却激光器热管理系统取热单元相关基础及关键技术研究
14.
Finite Element Analysis of the Effect of Pipe Cooling in Concrete Dams
混凝土坝水管冷却效果的有限元分析
15.
FEA of Conveyer Bush-roller Chain in Cooling Transporter;
冷却运输机滚子输送链的有限元分析
16.
Thermo-Mechanical Coupling Finite Element Analysis of Blast Furnace Copper Staves
高炉铜冷却壁热力耦合的有限元分析
17.
Finite element analysis of cement cooler grate plate based on ANSYS
采用ANSYS的水泥冷却机篦板有限元分析
18.
Simulation of Cooling Rate for CuFe15 Alloy by Single Roller Melt-spinning
单辊旋铸CuFe15合金的冷却速度模拟