1.
knee-braced bracket
拐弯托座，膝形悬臂托架
2.
Cantilever Length Calculation Analysis for Adjustable Jacking of Steel Tubular Scaffold with Couplers
扣件式钢管架可调顶托悬臂长度计算分析
3.
A projecting bracket that is used in classical architecture to carry the upper elements of a cornice; a console.
悬臂托梁，肘托古典建筑中用来托运上檐部分的一个突出的托架；支托
4.
crane ,jib (excl. portal and pedestal cranes), self-propelled
自动悬臂起重机（门式臂架起重机及支座式悬臂起重机除外）
5.
FEA of Lower Control Arm for Rear Double Wishbone Independent Suspension
后双横臂独立悬架的下控制臂有限元分析
6.
Application of Bracket with Double-cantilevers Longitudinal Beam in 0# Block of Cantilever Perfusion Beam
牛腿双悬臂纵梁用于悬灌梁0#块支架的研究
7.
constructed of two cantilevers that meet in the middle.
悬臂自支架伸出，彼此相接而筑成的桥。
8.
Control Arm Bushing To Suspension Cradle Retainer
控制臂衬套与悬吊架扣环
9.
Front axle Type Double arm independent suspensio
前桥型式双横臂独立悬架
10.
Optimum design of double-wishbone independent suspension based on ADAMS/Car
基于ADAMS/Car的双叉臂独立悬架优化设计
11.
Application of ADAMS/Insight in Double Wishbone Torsion Bar Independent Suspension
ADAMS/Insight在双横臂扭杆独立悬架中的应用
12.
Simulation and optimization of double wishbone suspension based on ADAMS
基于ADAMS的双横臂独立悬架仿真与优化
13.
Topological Optimum of Long Cantilever Truss under Transverse Concentrated Load
长悬臂桁架受横向集中力的拓扑优化
14.
Research on Cast-in-Place Cantilever Construction Technology of Cable-Stayed Truss Bridge
斜拉桁架桥的悬臂浇注施工工艺研究
15.
Most cantilever bridges have two arms of truss structure that meet or support a section between them.
大多数悬臂桥都有两个桁架臂用以对接或支撑两臂之间的桥段。
16.
Position the lower suspension arm at the axle bracket and rear bracket.
把下端悬吊臂放在车轴支架和后侧支架上。
17.
Truss Stiffening Suspension Bridge Cantilever Erection and Stability Study;
桁架加劲梁悬索桥悬臂架设过程分析及稳定性研究
18.
Simulation Contrast Analysis of Macpherson Suspension and Double Wishbone Suspension Based on ADAMS/Car
基于ADAMS/Car的麦弗逊悬架与双横臂悬架仿真对比分析