1.
Pump Failure Waterhammer in Heating Networks and By-Pass Pipe Choosen Principle Analysis;
供热管网停泵水锤及水泵旁通管选择分析
2.
Check valve applied in descreasing water hammer pressure when the pump stops;
止回阀在减小停泵水锤压力中的应用
3.
Numberical Simulation and Visualization Study on Water Hammer
停泵水锤数值模拟及其可视化技术的研究
4.
The Research of Water Hammer Caused by Pump Failure in Yumenkou Water Supply Project;
山西省禹门口工业供水工程停泵水锤的数值模拟
5.
Based on this study an optimal design and measures of water hammer protection have been established.
并根据暂态过程研究结果，提出了该取水泵站防止停泵水锤危害的优化设计方案及技术措施。
6.
Pump shut down large-scale accidents and countermeasures to prevent water hammer
大型泵组事故停机中水锤防护及对策
7.
Water Hammer Analysis and Prevention in Long Distance Pumping Water Transmission System;
长距离泵输水系统水锤分析与防护研究
8.
Characteristics and application of water hammer in multifunctional water pump control valve;
多功能水泵控制阀的水锤防护特性及其应用
9.
Research on the Optimization Strategy of Pumping System Valve-stroking and Water-hammer Protecting;
泵系统最优阀调节策略及水锤控制方法研究
10.
Design and Realization of the Numerical Simulation Software about Complex Pumping Long-Distance Water Distribution Impingement
复杂泵压长距离输水水锤数值模拟软件的设计与实现
11.
Signals from pumps' built in thermal contacts and moisture sensors are also connected to the PLC. If problem of overheating or leakage is found, the pump will be stopped automatically.
剩余污泥泵内置的温度及渗漏保护讯号将接至PLC,如水泵发生超温及渗水,水泵自动停止。
12.
In case of disuse for a long time, it is necessary to discharge the feed in the pump chamber completely and wash it with water or steam.
当泵处于长期停止工作时，应将泵腔内料液放净，并用水或蒸汽冲洗。
13.
Treatment measures for frequently start-up and stop of oil pump in hydraulic turbine governor
水轮机调速器油泵启、停频繁的处理措施
14.
Design and Optimization on Startup and Shutdown Mode of 300 MW Unit with Turbine-driven Feed Pump
300MW机组启停过程中全程使用汽动给水泵的设计与优化
15.
It stopped when it came to a spindle.
当出现了纺锤后它停止了移动。
16.
They are F. O. pumps， L. O. pumps, ballast pumps, fresh water pumps, sea water pumps, and bilge pumps.
它们是燃油泵，润滑油泵，压载水泵，淡水泵，海水泵，和舭部液舱泵等。
17.
drainage and irrigation pump
排灌用泵（农用水泵）
18.
lift [suction] pump
吸取泵，吸取抽机，提水泵